Announcement

Collapse
No announcement yet.

EMF and Scalar Waves

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • EMF and Scalar Waves

    I want to know more about Scalar waves and EMF and their effect on out body. Is there any way that we can save our body from the devices emitting these devices. Are they responsible for Cancer in human bodies?? Are their any gadget in the market by which we can save us from it???

  • #2
    Hey Micheal
    This is a big question for many, as the proliferation of cell and data transmission and other towers increases. A great place to start is here:
    Dr. Magda Havas, PhD
    Dr. Magda Havas, PhD » Dirty Electricity

    Here's another informative site with some practical solutions for the home:
    Welcome to Dirty Electricity | Could Dirty Electricity Be Making Your Family Sick?

    All the best,
    Bob

    Comment


    • #3
      Scalar wave detector


      The schematic, NEONDET.GIF, is a derivative of a microwave detector
      described in the February, 1980, "Ham Radio" magazine. As
      originally created, the circuit's purpose is to detect microwave RF
      standing waves, but with minor modification, it can also be used as
      an effective scalar wave detector.

      The schematic shows a round magnet epoxied to the NE-2 lamp, to help
      isolate it from EM signals. Additionally, the circuit should be
      enclosed in a metal box, or "Faraday Cage", with shielded I/O
      connectors.

      The power source consists of eight 9V batteries. Battery life is
      very nearly the same as shelf life, because the lamp is operated in
      "starvation" mode, drawing approximately 0.1ma.

      The 25K and 250K potentiometers are adjusted first to fire the NE-2,
      at approximately 60-70 volts, then adjusted until only the tip of
      the cathode electrode glows. The 100K pot is adjusted for optimum
      output gain.

      Notes:

      1. The 741 can be replaced with a 1458 cascade amplifier for
      better results.
      2. The RF loops in the NE-2 leads are mandatory to reduce
      interference as well as lamp current noise.
      3. Component values are not critical, and can be changed as
      required for the type of output device.
      4. Removing the magnet and Faraday Cage, and adding a
      capacitively coupled loop antenna will permit use as a
      microwave EM detector.
      --------------------------------------------------------------------
      If you have comments or other information relating to such topics
      as this paper covers, please upload to KeelyNet or send to the
      Vangard Sciences address as listed on the first page.
      Thank you for your consideration, interest and support.
      Jerry W. Decker.........Ron Barker...........Chuck Henderson
      Vangard Sciences/KeelyNet
      Whatever you can do,or dream you can,begin it.Boldness has genius,power and magic in it.Begin it now.

      Comment

      Working...
      X