Tweet
Magnetic Motor
hello
I got a question regarding pernament magnetic motors. Or to be exact I am looking for a motor that works in repulsion mode.
Thefollowing renders is the only such motor I know of and it has a problem - during running 2 shafts counter spinning in opposite directions.
Shortening 1 shaft and leaving another attached to potential load reduces it's power
I want to find a design which woks on single shaft rotor.
I am well AWARE that repulsion-based motors stop after a short time due to demagnetasation. I might have means to by pass this problem in bear future for which I need a design which would run in repulsion mode for a short time with normal magnets and have only 1 shaft
I tried Bedini Gate, but what I need to do will not work with bedini gate.
Also, who here can point me towards a gate design which is circular and has a sticky point at some point on it?
I am not asking anyone to build anything. All I need is eighter someone who tried many different designs and can answer me those questions or someone who can point me to such person.
The purpose of this is that I need to test certain material in a few month time which had prooven to be sort of useless in the design it was made for.
A different solution is needed so possibly pernament magnetic motor would be that solution.
Thank you very much
I got a question regarding pernament magnetic motors. Or to be exact I am looking for a motor that works in repulsion mode.
Thefollowing renders is the only such motor I know of and it has a problem - during running 2 shafts counter spinning in opposite directions.
Shortening 1 shaft and leaving another attached to potential load reduces it's power
I want to find a design which woks on single shaft rotor.
I am well AWARE that repulsion-based motors stop after a short time due to demagnetasation. I might have means to by pass this problem in bear future for which I need a design which would run in repulsion mode for a short time with normal magnets and have only 1 shaft
I tried Bedini Gate, but what I need to do will not work with bedini gate.
Also, who here can point me towards a gate design which is circular and has a sticky point at some point on it?
I am not asking anyone to build anything. All I need is eighter someone who tried many different designs and can answer me those questions or someone who can point me to such person.
The purpose of this is that I need to test certain material in a few month time which had prooven to be sort of useless in the design it was made for.
A different solution is needed so possibly pernament magnetic motor would be that solution.
Thank you very much