Newman Motor Finally Explained?

[Vinyasi]

It's a good thing you did this since my YouTube channel has been removed...

Part 3

Okay, this is Part 3. Enjoy.

https://youtu.be/z_nKxuLAcUM

According to Byron Brubaker, Jo had helium filled inside of those rotating permanent magnets. Apparently, if a glass globe were to be filled with helium and wrapped with a copper winding, then interesting EMs occurs in that winding. This I can't account for in my simulations except that I hint at a second source of energy sourced from these rotations blending with the DC coming from the battery pack.

[Vinyasi]

I don't know who Richard Willis is, but...

Sorry, I'm not on track with this topic but my intuition tells me that Newman machine is just a bigger version of Richard Willis first prototype (or rather Richard Willis incidentally constructed his first prototype in fashion similar to Newman machine). Try to find photos and compare, you will have very big help for successfully building Newman generator.

According to Byron Brubaker, Jo had helium filled inside of those rotating permanent magnets. Apparently, if a glass globe were to be filled with helium and wrapped with a copper winding, then interesting EMs occurs in that winding. This I can't account for in my simulations except that I hint at a second source of energy sourced from these rotations blending with the DC coming from the battery pack.

[vidbid]

https://youtu.be/z_nKxuLAcUM

According to Byron Brubaker, Jo had helium filled inside of those rotating permanent magnets. Apparently, if a glass globe were to be filled with helium and wrapped with a copper winding, then interesting EMs occurs in that winding. This I can't account for in my simulations except that I hint at a second source of energy sourced from these rotations blending with the DC coming from the battery pack.

Sorry about your channel being removed.

It was a good channel. I quote you in the following posts:

http://www.energeticforum.com/307577-post420.html and https://archive.org/details/GettingMoreFromLess



maintaining a perpetual voltage/amperage dipole

..looks like the powers that be are occulting this knowledge

..looks like they took down energybat's channel, as well

here's his stuff : https://www.youtube.com/watch?v=1wh9G1mU9UU




Now, currently looking at https://www.youtube.com/watch?v=yvI4dQ87Vws and


https://archive.org/details/GettingMoreFromLess

[Vinyasi]

I wasn't going to simulate any further since I'm tired of that ...

Responding to Vidbid...
http://www.energeticforum.com/renewa...tml#post310922

But this loss has prompted me to overwork since I have to repost as many missing videos as my patience can tolerate while inspired to make a few more.

I have to publicly thank Anthony Craddock for asking whatever happened to a duplicate location of the video you transcribed after having already privately thanking him. Forgetting about the former video, I reuploaded another plus almost all of the videos showcased on ...
https://josephnewman.info/videos
https://josephnewman.info/misc-vids

I seem to have misplaced one making analogy between homopolar motors / generators and the Newman device probably since I renamed a few upon posting them. Life goes on...

Capacitance may Induce Helium to Acquire a Magnetic Field?

I just got off the phone with Byron in which he assured me that Jo got a boost to his rotating central magnets by using sets of ring magnets surrounding sets of capped PVC pipes (coated with either wax or something similar to prevent getting nasty shocks; I wonder if epoxy would could make do?) acting as canisters containing helium. The magnets supplied an alternating push / pull effect while the helium, being diamagnetic, supplied a repulsive push effect.

Thanks for your boost. I appreciate it.

[vidbid]

Joseph Newman’s Motor Doesn’t Kill the Dipole of Current vs Voltage. It Maintains it

My Personal Backup Video Location of Your Videos:

Joseph Newman’s Motor Doesn’t Kill the Dipole of Current vs Voltage. It Maintains it in Perpetuity
https://vimeo.com/273152422

Cooperation will Solve this Mystery of the Newman Motor
https://vimeo.com/273152933

Some of my other favorite video saves about Newman:

newman motor batteries too dead to run the motor until the capacitor connected
https://vimeo.com/273153410

I also saved this video (Geoffrey Miller Energy Bat Labs Live Call) available at https://www.youtube.com/watch?v=R8QLWrPpQaM

[Vinyasi]

Divide and Conquer the Synthesis of Electrical Watts

http://www.energeticforum.com/310957-post97.html

[Majestic81]

WOW WOW WOW

I am so glad to see you are finally starting to wise up and not believe everything you see on YouTube or hear about from this source or that source. I actually have an original Joseph Newman Energy Machine book from back in the 1980's. I was very intrigued by what he wrote. But then I saw an article where he was actually driving a car powered by one of his motors and some 9 volt batteries. I am sure you are thinking the same thing I thought. He can run a car on 9 volt batteries! That is amazing! Then I found out he was using a couple of thousand of them connected in series and parallel to give him a couple of thousand volts at a few amps. He was just trading volts for amps. Nothing magical or OU about that at all. I was very disappointed in him.

Now maybe you can understand why those of us that have been at this a while are not so quick to jump on the bandwagon for every guy that comes on YouTube or this forum claiming he's "GOT IT" and then doesn't show any real proof he has anything.

I most definitely believe OU is possible. But I am very skeptical of those making wild claims when they show nothing to back those claims up. And since I have been at this a while I have seen a lot of the same old stuff shown over and over again that still doesn't work.

Respectfully,
Carroll

Nah, he was creating a maximum potential difference to create the magnetic field with minimum input and collapse it with potentially more output.

Ray

[Vinyasi]

I like this ...

... a maximum potential difference to create the magnetic field with minimum input and collapse it with potentially more output.

Ray

Succinct and to the point.

[Vinyasi]

Dave Bowling's 3 Battery Generator includes Newman's Unknown Extra Energy Source

Ever since I managed to understand Newman's eighth edition enough to simulate it, I've been of the opinion that - although it's overunity - it's not entirely a mystery where the extra energy comes from.

It comes from the spinning magnetic field surrounding the rotating bar magnet/s in the center of the coil. They produce lots of amps, but not much volts. These sinewaves then blend with the square waves arriving from the battery pack, and then chopped up by the commutator, creating a blended waveform.

The massive coil is doing more than merely filter out current flowing from the batteries. It also draws current through the rotating magnetic field surrounding the spinning permanent magnets. As to where this excessive current comes from, I don't know...

But I do know that most of it goes to waste due to the poor coupling coefficient between the spinning magnetic field and the massive coil which surrounds it.

Well....

What helped me understand Dave Bowling's Three Battery Generator was the key advice from him and others replicating his work, to: "hand turn the axle of the D/C brush motor after five minutes of waiting for it to self-start if it should fail to". This is exactly like the Newman motor. Thus, I began to attempt a set of simulations...

Magneto Charger

It's possible to simulate increased current drawn from a source (the sparking brushes in these examples) whenever the load increases (represented by adding more batteries that need charging) along with decreased current at the initial source (the rotating magnetic field of the magneto rotor represented by the A/C voltage source in these simulations) ....

Massive Charge

The most interesting part is that it matters what the wiring position of the brushes are in relation to the commutator. If they're on the side of the commutator facing the rotor coils, then OverUnity will result. But if the brushes are sparking on the side of the commutator opposite the rotor coils facing the circuit surrounding the D/C motor / alternator, then smooth half sinewaves (similar to a crystal radio audio output) will result and no OverUnity...

D/C Rotary Charger

More information about these simulations.

Short animation ...
https://vimeo.com/vinyasi/magnetocharger

[vidbid]

interesting

[VIDEO]https://www.youtube.com/watch?v=CrJIzrmX1mI[/VIDEO]

https://www.youtube.com/watch?v=CrJIzrmX1mI

Joseph Newman - YouTube

interesting

[ilandtan]

The most interesting part is that it matters what the wiring position of the brushes are in relation to the commutator. If they're on the side of the commutator facing the rotor coils, then OverUnity will result. But if the brushes are sparking on the side of the commutator opposite the rotor coils facing the circuit surrounding the D/C motor / alternator, then smooth half sinewaves (similar to a crystal radio audio output) will result and no OverUnity...

Vinyasi,

Could you provide a picture of this so I can visualize the orientation of the sparks in relation to the magnetic field?

Thanks!

[vidbid]

[VIDEO]https://www.youtube.com/watch?v=CrJIzrmX1mI[/VIDEO]

https://www.youtube.com/watch?v=CrJIzrmX1mI

Joseph Newman - YouTube

interesting

This is the Newman movie..

also found his south african patent application https://patents.google.com/patent/WO1983000963A1/

[vidbid]

Gas Being Used In Newman Patent Application

https://youtu.be/z_nKxuLAcUM

According to Byron Brubaker, Jo had helium filled inside of those rotating permanent magnets. Apparently, if a glass globe were to be filled with helium and wrapped with a copper winding, then interesting EMs occurs in that winding. This I can't account for in my simulations except that I hint at a second source of energy sourced from these rotations blending with the DC coming from the battery pack.

I see that idea about gas in the Newman's patent application:









https://patents.google.com/patent/WO1983000963A1/

https://patentimages.storage.googlea...83000963A1.pdf

https : // postimg . cc /
zVyZmWxm/ed409378
Wt4xrgLD/143a2c36
sQLm5B7S/f4e1aa31
rD99QZ5q/18842906

Also, I found another patent application:

https://patents.google.com/patent/WO2006101494A1

https://patentimages.storage.googlea...06101494A1.pdf

Old German interview: https://www.youtube.com/watch?v=Fi8FbMHNc8Y

The video shows Newman with helium in his lab: https://goo.gl/9vtxCw


The following video clip Joe talks about his helium device: https://goo.gl/aHjRiH

[vidbid]

Patent Application #WO2006101494A1 by Joseph W. Newman (so-called Big Eureka)

Before I mention what I'm going to mention as referenced by the above title, I would like to state that I went back and corrected a majority of images so that they now display in this thread. Who know how long they will last?

https://patentimages.storage.googlea...06101494A1.pdf

Patent Application #WO2006101494A1, at least the PDF version of it, shows what I believe to be diagrams of the commutator assembly used in the so-called "Big Eureka" energy device.

Here is the commutator, according to the patent application. This is it. I recognize it:



So simple, and yet so elegant



https : // postimg . cc /
LJk1sm13/6ca11181

Fig. 2 is standard double hub 3 for battery contacts with leads 4 and 5 leading to opposite firing segments of No. 1 with shortout segments 2 that are connected with dark solid line from segment 2 to other segment 2. That design results in a collapsing magnetic field of coil 5 of Fig. 1 producing current and magnetic field that maintains torque on rotating 20# magnet 1 of Fig. 1. Direction of input current is reversed, of course, at every 1/2 cycle.

Source:

https://patents.google.com/patent/WO2006101494A1

https://patentimages.storage.googlea...06101494A1.pdf

I suggest you download your copy now for safe keeping.

[vidbid]

Commutator Design from the Patent

Before I mention what I'm going to mention as referenced by the above title, I would like to state that I went back and corrected a majority of images so that they now display in this thread. Who know how long they will last?

https://patentimages.storage.googlea...06101494A1.pdf

Patent Application #WO2006101494A1, at least the PDF version of it, shows what I believe to be diagrams of the commutator assembly used in the so-called "Big Eureka" energy device.

Here is the commutator, according to the patent application. This is it. I recognize it:



So simple, and yet so elegant



https : // postimg . cc /
LJk1sm13/6ca11181




Source:

https://patents.google.com/patent/WO2006101494A1

https://patentimages.storage.googlea...06101494A1.pdf

I suggest you download your copy now for safe keeping.

Compare the above diagram from the patent to the image below of Newman's motor: