Announcement

Collapse
No announcement yet.

The Resonance Energy Device Explained

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • The Resonance Energy Device Explained

    Hello everyone,

    i am pleased to introduce some new information about the resonance energy device, there is a new presentation available on the following link :

    http://free-energy-info.com/Mohamed.pdf

    the resonance energy device depend on a special capacitor/coil, so we could replicate the squared electromagnetic flux very easily, the idea is very simple but very difficult to understand, it's a new kind of capacitor, a one dimensional capacitor that exist only when the device oscillate!! when we do that the needed rotational energetic symmetry will exist and the correct door will be opened for a massive electrical energy to be present for free

    experienced people are invited to develop the device because the presentation will cover only the heart of the system.

  • #2
    interesting

    Hi Med, Do you think , when you move a magnet closer to a piece of steel , the flow becomes faster moving , or becomes more dense( compressed) but keeps the same velocity?
    Thanks for the link.
    artv

    Comment


    • #3
      Hello

      i think the flow will be just compressed.

      Comment


      • #4
        Negative...Flow Expands...

        Hello to All,

        @ Shylo:

        Whenever you approach a piece of Iron to a Magnet or Magnetic Field, the Iron becomes "part of the Magnetic Field environment"...this is called magnetic Redirection of flow, therefore the Magnetic Flow Expands into the Iron...

        In order to obtain a "Compressed Flow" is whenever you approach Two Magnets facing SAME polarity, meaning North to North or South to South...what T.A (Ken Wheeler) calls Counter Voidance Compression and We all call "Repulsion"...right on the money Ken!


        Regards



        Ufopolitics
        Principles for the Development of a Complete Mind: Study the science of art. Study the art of science. Develop your senses- especially learn how to see. Realize that everything connects to everything else.― Leonardo da Vinci

        Comment


        • #5
          i have a problem in the pick up coils...

          i opened this thread to discuss the resonance energy device, i am the writer of this presentation

          http://free-energy-info.com/Mohamed.pdf

          it explain the resonance energy device, the device depend on an extended Tesla bi-filar coil where the capacitor is a part from the coil!

          Back to 1894 and take a look at what Mr. Nikola Tesla said about his bi-filar coil:

          My present invention has for its object to avoid the employment of
          condensers which are expensive, cumbersome and difficult to maintain in
          perfect condition, and to so construct the coils themselves as to accomplish
          the same ultimate object.


          for more information please read the full presentation, now the problem is the obtained electric power using the E-TBC is a pure reactive power

          the pick up coils in the resonance energy device will correct the reactive power using a kind of serial/parallel resonance... this situation will provide the maximum current /voltage needed to charge the electrolyte capacitors banks...

          Now the problem is that what is the best way to arrange the pick coils ?
          the attached photo show how Don connect his diodes with the receiver/transfer coils.
          Attached Files

          Comment


          • #6
            Originally posted by med.3012 View Post
            i

            it explain the resonance energy device, the device depend on an extended Tesla bi-filar coil where the capacitor is a part from the coil!

            Back to 1894 and take a look at what Mr. Nikola Tesla said about his bi-filar coil:

            My present invention has for its object to avoid the employment of
            condensers which are expensive, cumbersome and difficult to maintain in
            perfect condition, and to so construct the coils themselves as to accomplish
            the same ultimate object.
            This quotation is about pancake coils, isn't it? Pat 512340.

            Comment


            • #7
              the extended pancake bifilar coil is the key !

              when we extend the capacitive side of the famous Tesla pancake bifilar coil we arrive to the point where we could construct a parallel LC without the employment of condensers,

              when we combine magnetism and electricity in the same device the power will be replicated and amplified with Radio Frequency, the obtained power is an amplified reactive power... the collection system must correct the phase using a correction capacitor in parallel with L2 coil.

              Comment


              • #8
                proposal circuit need to be tested.

                proposal circuit need to be tested.
                Attached Files

                Comment


                • #9
                  Originally posted by wrtner View Post
                  This quotation is about pancake coils, isn't it? Pat 512340.
                  The Patent clearly states that the patent relates to coils of all types and even arrangements that are not classical "looking" coils.

                  I would here state that by the term coils I
                  desire to include generally helices, solenoids,
                  or, in fact, any conductor the different parts
                  of which by the requirements of its applica~
                  tion or use are brought into such relations
                  with each other- as to materially increase the
                  self-induction
                  .
                  Patent.
                  Patent US512340 - Nikola tesla - Google Patents

                  One of the advantages to this coil arrangement is that the current portion
                  of the L/C "activity", is displacement current due to not needing an external
                  capacitor to get the required capacitance for resonance at a particular frequency.

                  I arranged a HF setup with series connected bifilar wound coils but still used
                  external tuning capacitors to get the exact frequencies I wanted, however
                  by using series connected bifilar wound coils I was able to get a relatively low
                  frequency with very low resistance coils and was able to utilize only parallel
                  plate air variable capacitors for tuning.

                  From a 12 volt input 8 primary turns and 20 secondary turns I am able to
                  exceed 1600 volts peak to peak 565 volts RMS perfect sine wave on the
                  tanked secondary with a pulsed DC input of about 12 volts in a no load
                  situation.

                  Transformation ratio is only 1:2.5 but voltage rise is 1:133 using peak values
                  12 volts pulsed in and 1600 peak to peak on the tank (not output), that's
                  resonant rise. Without the resonant rise the setup would not be able to
                  achieve proper conduction in the fluro tube. Without resonant rise the
                  secondary voltage would be lucky to get to over 30 volts, Resonance is
                  useful like that.

                  I haven't finished with the experiments.

                  The setup will strike and light fluro's fairly well with proper conduction current.
                  https://www.youtube.com/watch?v=vFOHk_0IDZg

                  ..

                  Due to my limitations and that of my equipment no reliably accurate measurements have been made on this setup yet.


                  ..
                  Last edited by Farmhand; 11-18-2014, 12:01 AM.

                  Comment


                  • #10
                    Nice

                    From a 12 volt input 8 primary turns and 20 secondary turns I am able to
                    exceed 1600 volts peak to peak 565 volts RMS perfect sine wave on the
                    tanked secondary with a pulsed DC input of about 12 volts in a no load
                    situation.



                    there you have it
                    artv

                    Comment


                    • #11
                      The E-TBC is the heart of resonance energy device, in my opinion we should work with it....

                      thanks

                      Comment


                      • #12
                        Don Smith

                        Thanks for the lost Don Smith stuff. I am watching his energy generator/collection talk.

                        Mike

                        Originally posted by med.3012 View Post
                        i opened this thread to discuss the resonance energy device, i am the writer of this presentation

                        http://free-energy-info.com/Mohamed.pdf

                        it explain the resonance energy device, the device depend on an extended Tesla bi-filar coil where the capacitor is a part from the coil!

                        Back to 1894 and take a look at what Mr. Nikola Tesla said about his bi-filar coil:

                        My present invention has for its object to avoid the employment of
                        condensers which are expensive, cumbersome and difficult to maintain in
                        perfect condition, and to so construct the coils themselves as to accomplish
                        the same ultimate object.


                        for more information please read the full presentation, now the problem is the obtained electric power using the E-TBC is a pure reactive power

                        the pick up coils in the resonance energy device will correct the reactive power using a kind of serial/parallel resonance... this situation will provide the maximum current /voltage needed to charge the electrolyte capacitors banks...

                        Now the problem is that what is the best way to arrange the pick coils ?
                        the attached photo show how Don connect his diodes with the receiver/transfer coils.

                        Comment


                        • #13
                          3 Strokes

                          Don Smith drooled as he gave his talk. The man had just had 3 strokes. Don said many business deals were preventing him from giving more elaborate device descriptions as to just how advanced these Tesla based systems have become, so he wanted to give just a simple demo to get the idea across.

                          The biggest thing he said that hit home with me was that people who had TESLA COILS could make as many more as they wanted to but use the additional units to collect the energy coming from the transmitter.

                          Or for as many more Tesla coils one could build to collect the same energy from the transmitter would give the operator that much more energy in multiples.

                          As he showed one of his many devices he explained that one of the coils was transmitting while the other 3 (in this case) were tuned especially to collect.


                          His little wooden board was just simple high voltage source with coils.

                          Mike

                          Comment


                          • #14
                            I get the feeling that perhaps the secondaries of these types of transmitters need to be standing quarter wave resonant and the receiver coils need to have the same length conductors and identical properties to work at their best.
                            As per the tesla patent.

                            Comment


                            • #15
                              Quarte Wave

                              Originally posted by lotec View Post
                              I get the feeling that perhaps the secondaries of these types of transmitters need to be standing quarter wave resonant and the receiver coils need to have the same length conductors and identical properties to work at their best.
                              As per the tesla patent.
                              This information in this patent may be relevant

                              Electromagnetic systems with double-resonant spiral coil components

                              Patent US20100059692 - Electromagnetic systems with double-resonant spiral coil components - Google Patents

                              Comment

                              Working...
                              X