Hello,
i'm planning a version of this motor :
The Tom Bearden Website
If anyone has gone this route before it would be great to hear what your experiences were.
I don't plan on using angled magnets, just the difference in attraction between both ends of the rotor magnet to induce rotation.
I also plan on using at least two rotor magnet assemblies, experimentation will reveal the limits.
I bought a cheap Chinese laser cutter that i'll use to cut the parts after ive upgraded a few things on the cutter.
Cyan.
i'm planning a version of this motor :
The Tom Bearden Website
If anyone has gone this route before it would be great to hear what your experiences were.
I don't plan on using angled magnets, just the difference in attraction between both ends of the rotor magnet to induce rotation.
I also plan on using at least two rotor magnet assemblies, experimentation will reveal the limits.
I bought a cheap Chinese laser cutter that i'll use to cut the parts after ive upgraded a few things on the cutter.
Cyan.
Comment