Figuera Device, Part G Continuum.( Serious Builders Only)

[Aaron]

more of MM's lies

Blocked again after one post.

MM

Another example - the entire time he could post and is acting like he couldn't. I can see when he posts and I can see when he deletes his own posts since I'm the moderator. He is misleading all of you to believe something was happening when it wasn't. I never banned him until today - before today, I don't follow this thread, nor do I care what he has to say so no reason for me to ban him based on something I'm not reading - not going to happen. He is gone now and it is because of his constant slander against me, lies, trolling, etc...

[Aaron]

Donald Livesay is spreading disinformation

I think i still can't post.

MM

His deception acting as if he had problems when he hasn't.

[Aaron]

mm banned

Attn Aaron, or moderators, member Marathonman has pm'd me several times to say that he can't post here anymore, and asked could i make you aware of this and look into it for him.

regards Cornboy.

He has always been able to post and is claiming that to make it look like he's being suppressed. He's played these games before. He is banned now because of his trolling in other threads, spreading disinformation and lies and now he is gone. He has slandered me too many times in this forum and I'm sick of his mouth.

[marathonman]

BS

Blocked again after one post.

MM

[marathonman]

Primary and Secondary

Referring to William Hooper and the double emotional electric field produced by the twin magnets one moving in, the other moving out in unison is in my book or understanding the exact thing as Figuera's electromagnets one moving in increasing the other moving out decreasing.
this effect is the cause of the doubled electric field that the secondary is exposed to. the relative unison back and forth motion of the primaries causes currant to flow in the secondary and produces an opposing field to the first. with that opposing field in between the opposing primaries it will be like grabbing the secondary and with your hand and raking it across the doubled electric field in an orderly fashion. but of course the secondary has to be connected to a load for this to take place. the opposing primaries efficiently move this secondary field from side to side with ease through the doubled electric field totally unlike the standard geny.
the lenz law keeps the primaries separate but the electric fields does not know this and is combined to form a doubled electric field presented to the secondary and the primary purpose of the primaries are to impart motion into the secondary across this electric field.
this is of course just my two cents worth.

I could not find wire like the mentor used so for testing purposes i chose to rewire my part G with Square wire. i will post pis very soon.

Thank you Cornboy, i don't know what was wrong but it seams to be fixed or unblocked. i was trying some to copy and paste from a word doc so that could be part of the problem but i never had it before until three weeks ago.

MM

[Cornboy 555]

Attn Aaron, or moderators, member Marathonman has pm'd me several times to say that he can't post here anymore, and asked could i make you aware of this and look into it for him.

regards Cornboy.

[marathonman]

post

I think i still can't post.

MM

[marathonman]

Good Idea

That would be a good idea Bistander as your opinion or response is entirely not needed or wanted. thank you kindly though and have a good day.

To all:

I do understand as i have been so terribly busy myself and horribly distracted by really stupid matter, ie.... wish it was legal to strangle an alcoholic room mate that wants nothing better to do on his off time then to drink beer and chase really ugly hookers and bring them to the house.

I hope you all understand what i have posted in the last few weeks and have a better mental picture of what is taking place. apparently aligning that up with a working model was a little more difficult then i had originally expected but i or rather we will get there. the two are finally aligning up just nicely.

Glen:

Good to hear you are still chugging forward.
Ps. i love FreckleFace.


MM

[GlenWV]

...and another

...is still here.

Had one part G 'professionally wound'. I'm not happy with it, but will leave it intact.

Am waiting to get more transformer cores from UPS devices which will be life-cycled in the near future.

These will be wound with flat motor winding wire purchased from the same motor shop that balanced my UFOP asymetrical armature.

Did get some plastics from FreckleFace.com to use in making brackets, etc, for commutators and so forth.

So, if things seem quiet, it doesn't mean that folks aren't working on things. (My machinist friend will have 3 major projects coming out for me in the next few weeks.)

glenWV

[Cornboy 555]

Still Here MM, still working on it.

Bistander, the stirring antagonist, still working on it too, i see.


Regards Cornboy.

[Shadow119g]

Still here

I am still here, but, I have had to attend to house problems and other stuff.
Thanks for all you have done!
Shadow

[marathonman]

The conversion of mechanical into electrical energy is very costly. the mechanical energy used to overcome the attraction of the stator to the rotor is so powerful that the whole over unity thing is completely obliterated thus why the standard mechanical rotating generator is a complete waste of time even though the output used to excite the electromagnets are around 10% of the total output making the mechanical output surpass the 90 % mark. (Lenz Law)

Figuera on the other hand has figured out that the mechanical part can be eliminated all together by using two primaries of the same polarity in unison to exactly mimic the actions of the standard generator using the Lenz Law to maintain the pressure between them thus eliminating the 90% used for the mechanical rotation allowing the device to use that 90 % toward the output and even lower the input to the device in my opinion less than 10 % from the use of part G making this generator the most efficient of it's kind.

once the primaries are up to working magnetic field strength, the currant will pass right through the primaries as if they were a straight piece of wire as also part G using only what it needs to maintain the field as the rest goes right on by or is stored in the magnetic field for later use. if the field is at a certain field strength and the same amount of currant is supplied to it it will not accept any further currant into the magnetic field. it uses only what is needed to to increase the field strength of the primaries as the field of the primaries are maintained at 80 to 90 % of their field strength even when taken to their low position.

the logistics of this device is absolutely mind boggling to say the least and is a testament to the utter Genius of Clemente Figuera. the people of the Tesla time are true leaders in their field thus making our so called leaders from our time seam like school girls playing with dolls.

using the analogy of marbles flowing though a piece of wire is sheer insanity to the fifth degree.

really love Michael Tellinger's video's, someone with the balls to stand up and say "Hey, I don't think so".

MM

[marathonman]

Where did it go

I guess the Figuera drive ran out of juice.
i will keep on posting as i test my part G soon. just got back in town tonight, out of town for a while and darn glad the job is finished. i really hate fixing someone elses F-up but it had to be done.

i really can't believe everyone else stop posting. a few set backs and then quite, I DON"T THINK SO.
there is enough information on this thread to do some serious testing unless you are the type like my ex that just laid their and let someone else do all the work.

MM

[marathonman]

Part G

The magnetic field created by the currant flowing through the conductor opposes the original currant flow. this magnetic field is then amplified by the core as reverse EMF to curtail the currant flow through part G on a dynamic basis. since the currant will equalize over a period of time, Figuera rotated the brush to dynamically change the currant on a steady basis through addition or subtraction of coil winding's as the brush rotated. thus two coils in opposite direction being of positive nature will have two north opposing magnetic fields allowing each one to operate separately but in complete unison. they have the same attributes as the primaries as constant pressure is maintained between them and since there are at least two contacts at a time, this is the perfect avenue to inject the secondary output, the power from the decreasing electromagnet plus the reducing side of part G to attain the amplification to the increasing electromagnet.

MM

[marathonman]

Primaries N Secondaries

Quote;
"Remember how a squirrel cage motor works. There is no current or voltage going into the rotor. It develops it's own current through induction and establishes it's own magnetic field only as a result of the relative motion between the rotating field and the core. If the core catches up to the rotating field the relative motion is reduced and the current in the rotor reduces slowing down the rotor until the relative motion is fast enough to induce a stronger field in the rotor so it can be pushed around by the rotating field again. They don't combine into mutual fields as that would stop the relative motion. Without having a rotating rotor like the squirrel cage motor to provide the difference between the rotating field and the induced field on the rotor it takes a bit of creative thinking to accomplish the same effect in a stationary condition of the cores in clemente's generator. Maybe that will resonate with classical training. There is no electrical connection from primary to secondary and after induction in the secondary from the primary's, it produces current in the secondary (Y) which creates another field inside Y they part company and the primaries become the motive force that exerts motion onto Y provided Y is a closed circuit with resistance of it's own." ( ie. a load.)

So from the pic below, once the secondaries create it's own field the primaries can quite easily move the field from side to side changing the direction of EMF producing AC. in the case of the Figuera Generator a load has to be present for the device to work like the voltage regulator of a standard Generator, the regulator is the phantom load and the small fraction of the secondary in the Figuera device is the phantom load.

the load requirements from the secondary are further reduced by the low primaries being basically shoved out of the secondary into it's own core as it is reducing. as it has been stated that the magnetic field is just reducing not retracting but the coil see's this as retracting and produces voltage and currant in the coil. this power is what is shoved into part G at the brush along with the reducing field in half of part G's low side to attain the amplification that has been stated in the above post.



As part G spins, what is changing is the amount of self induction, reverse EMF, the resistance to currant flow (Magnetically) through the brush rotation on the coil wound around the core. the core amplifies this self induction and thus regulates the currant of the twin inductors or reactors that are kept separate by two north face magnetic poles. each are independent but in complete unison, one increasing, storing energy from the system, one decreasing, releasing energy into the system.
the secondary is there to replace losses occurred in the process.

MM