Imhotep's Radiant Oscillator Video

[Lidmotor]

Amazing Aromaz solid state CFL circuit-My Replication

OK Good news and bad news. Good news is I got it to work. Bad news is I don't really understand it. It was an all day project. I did not run the way the diagram showed. Probably something I did wrong. In the video I don't mention it but I think that I either have the 2n2222 transistor in backwards or the diagram on the package of (15) it came in was wrong. It caused me much greif. After hours of playing with it I finally had success and there was light Take a look in the video of where I ended up putting the earth ground---right into the HV of the coil. Something is not right or something strange is very very right.

Aromaz-- You are right the coil hums. I did not try multiple light bulbs yet but I will. I added a 5m pot at the 2222 base to get it to run and a 25 ohm rheostat at the battery to control current. Thanks so much for the great circuit.

Ren-- The reason that I keep burning up 555 chips is because I am not protecting them with an optoisolater. On my Lunch box circuit I used one in the cap pulser part and have never had a problem.

Bodkins-- You are going to like this one. It really makes use of the earth ground well. Maybe you and Nat can explain why.

YouTube - Aromaz CFL Circuit

Cheers,

Lidmotor

[Aromaz]

More info

? COLPITTS OSCILLATOR = do not know. Firt time I saw this word, but then I am a pure novice - only 3 months into this.

Googled it quickly but does not looks anywhere similar. Neither does the wave form. As I said before: Looks like jumping Mathilda (Ozzie kangaroo). See attached file. Scope on line between 3055 and positive of coil.

When I scan the lights with scope probe, (not connected) there are two clearly different waves. One is as on scope below, then there is another much slower wave that pulls up and go off before I can capture it. This is a very high voltage, out of ability of scope/probe for now. However, on the third photo you can also see this wave passing through the fuorecent tube.
I could even measure it with my infrared tachometer at 36.7 Pulses per Second. The scope only captures the 4.8 KHz.

RE 555 smokes:
I will post that complete curcuit with which I had most success later today (once I became able to convert the file from Rhino to jpg).
At present I would dare to say my problem seems to be a back EMF that somehow burns through/over the protection diode (2n4148 and 2N4007) and then smokes the IC. Each time the 555 died, I find also this diode shorted out. It always happens on long runs of more than 30 minutes.

On this wave - also no spikes at all.

[Aromaz]

Ground or not Ground

@LIDMOTOR

With one or two ltubes, the ground increases the illumination. But once I have more than two tubes connected, the ground dimms the illumination. Without the ground, the second wave then seems to come into effect. With ground the scope does not see the second wave. (see above)

My ISP is frustrating the blue moon out of me today. Erratice and dead slow. Still trying to download the LIDMOTOR video.

[hh1341]

Guys the RV's number is 1.618
Forgot to post.

Ah......the golden ratio!

Carl

[Aromaz]

Nope, I am more spooked !


Imhotep / Aaron - I think I would need some knowledge here.
Is it possible to refer to dr. Peter Lindeman?
I feel like a dog chasing a truck here, caught up with it and does not know what to do now! I am reasonably sure there must be some sort of explanation.

Now I thought "Let me see how well it charges a capacitor and what bang it will make; out comes 80Vdc 10,000pF. Connect HV lead to positive, negative to battery - exactly in place and position as CF lights. Charge 10 seconds, removed - short....nothing?

Checked wire - disconnected and hold close (1 to 6 mm) have spark jumping; each time all the time. Tried with spark gap, tried with dead connect - same results. All the time the coil sings its song, for sure energy is flowing!

Charged 30 seconds, removed - short .....nothing :surprise:
Turned around HV to negative, charged 20 seconds....nothing
Connect capacitor to battery, one second and 10 seconds, short BANG! Each time. Tried with 10Vdc 400pF cap - same dead silence with circuit.
Removed earth wire - same sequence same results.

Reconnect 1 light - light up, reconnect 4 lights - all normal light up.

@Lidmotor: I checked my 2N2222, according to my circuit diagram it is right. Looking at face, Left is #1 Emitter, center is #2 base right is #3 Commuter. Attached photo of circuit. Blue is to Base of 3055, Red from Positive on battery and black is Ground.

Four tubes, connected to earth I have around 70% same as normal 220V wall socket light (I used old Minolta SLR - before digital age - camara to measure light) - running from 12V dc battery, lightest cheapest non-brand automotive coil - and only drawing 11 mA at positive pole of battery. Yes, when sparking the negative terminal to last light the amps drops to 7 mA.

Lidmotor - thanks for the duplication, your work and input. As usual - nice clear video. Much appreciated.
Name is Aroma(z) like in nice smell from natural essential oils - and the end of all Z.

[Aromaz]

Lite This one

Sure do capture me more and more. See photo below.

18W 220v Fluorecent tube is connected to HV line from coil.
Two other CFL tubes is connected in series to the negative line from the coil.

As soon as they are closer than 60cm from each other, both sets lit up. Only single connection line. AND they are bright.

Now, play around with your hand by touching different part - but not the HV line. Two of my sets now running no-stop 9 hours and all parts are room temperature - cool. When ground is removed, there is even high voltage that you can feel on both positive and negative terminlas of battery!
Mystical, What is this? Dare I say the dream words - Radiant/Vacuum??

Just after writing above about battery I thought to go and check the voltage. My battery charge went UP !!!! From 12.09 volt this morning to 12.48 this afternoon!!!! The other two systems were fully charged at 12.48v; still the same and 12.51v this morning now 12.53v. I might have made a mistake, this can not be? Could be athmospheric or temperatue? There is definately no radiant spike (closure) and definately no back EMF (terminate). Also with the whole circuit been broken by the gas tubes there is not current possible? I will have to look more closely into this.

I envey those in the Western world. My coil is real low class, cheap budget no-name brand - output 6,800 volt on Imhotep original radiant circuit. I am sure some of you will find very interesting results with better coils. Nothing better to be found around. I plan on ordering a parcel of good stuff from States soon.

Frequency emited is high and strong. I can use my electronic multimeter without any cable attachements (pulled out) and read the fq anywhere near and around the setup, within distance of 50 to 80 cm. With cables plugged in(antenae) , but not connected the range goes up to about 2 meters. At some spots i.e. 45 degree up from coil, the frequency changes suddenly down from 4,800 to 300/400.

WARNING: My mobile phone does not work within 1.5 meters from system.

Now I need some sleep......no, make it a nice good spa massage while I think

[nat1971a]

YouTube - TESLA'S RADIANT ENERGY WIRELESS TRANSMISSION - UPDATE 18 /EDWIN GRAY HYBRID CIRCUIT - many wireless lights



anyone for wireless lights?

[braden]

demo of plasma spin

Here is a very interesting experiment looking at plasma spin
YouTube - JK Plasma Magnetics Experiment 1

[nat1971a]

YouTube - TESLA'S RADIANT ENERGY WIRELESS TRANSMISSION - UPDATE 19 /EDWIN GRAY HYBRID CIRCUIT


truckloads of wireless lights anyone?

[Aromaz]

Brain dead ? 0.79 mA ????

I am off to TRY and sleep. This day really mixed my brain. I went out to buy more brand new CF Lights - just to break them open!

Here you go:
5x18W phillips globes (gas tubes only), 1X18W sylvania, 1x Toshiba 18W tube (Warm light) and 1x Phillips 32Watt long tube - Total 158W. Negative from coil onto one end of the series of 6x 18W CFl's, the shorter 18W Toshiba is also connecting here. Earth wire to the end of the long phillips 32w tube, the Toshiba is not connected to anything on far end. Finally the high voltage line connects in middle between CFL and long 32w Tube. All light up, barely flikker and each about 45% of the 240V illumination as tested with Minolta camera light meter.

To answer your - and my question - I connected the amp meter, but the meter's resistance caused lights to dim probably 30%. Anyway, that is the second photo. I can not believe it, so I connected an analog meter with scale of 0..50 mA - it barely moved.

Lastly, yes, the lights does have somewhat of illumination without being connected at all - wireless transmission - though I did not persue this direction much because of my weak coil.

I failed all day to get second coil either in series or parallel connected i.e. Modified Imhotep circuit. Maybe someone can help out with this one while I try to sleep?

If you want to see a totally confused Scope - put a small toroid coil on the end of the probe and move that around the visinity of this complete setup.

Lastly: These photos were taken with camera flash, thus less illumination appearance in lights than when not using flash.

Have a nice day!

[Bodkins]

I had all this around a month ago no sleep and light everywhere
got a picture ffor you and some videos later there uploading
Back soon

[jibbguy]

'Scopes as cheap RF meters

Sounds like you are doing some very nice work , Aromaz

If i could inject an aside: Regarding your idea of the coil at the scope probe, this reminds me of an old trick we used to use to check the RF radiation of devices (quickly testing the effectiveness of shielding schemes without an expensive RF meter or having to go into the Faraday cage, which was a pain):

Simply clip the ground of the scope probe to the tip; creating a "loop", and wave it slowly around / near the device. We used to see quite graphically how RF would "hover" over metallic surfaces and not be shunted to Earth Ground; which is a pretty strange effect when you think about it

[Lidmotor]

Sleepless nights

Aromaz-- Sorry that I mispronounce your name. It is Aroma-zzzz. I wish that I could get more ZZZZZs. This stuff keeps me awake too. Thanks again for getting envolved with this and sharing.
I did have the 2n2222 wired correctly and the package label was wrong. A warning to others who may buy the Radio Shack package of (15) assorted 2n2222 "like" transistors.
Something very strange is going on with this circuit. I was getting mild shocks at places in the circuit way up stream where there shouldn't be any HV. This was happening before when I was using the Bedini fan circuit. Aromaz when you mentioned the low amp draw and the battery voltages climbing a light went on in my brain. Last night I ran the system a long time, it was stone cold, and the analogue amp meter was hardly registering anything. The coil was humming along and the light was on. If I touched the rehostat leads at the source battery I got a mild shock. In my particular case I may be getting energy from the house somehow from that ground lead. I hope not. I may have to drive out to the desert and run the experiment again.

[Bodkins]

YouTube - Bodkins 28 Aromaz rep1.AVI

YouTube - Bodkins 29 Aromaz rep2.AVI

got some scope shots next video

@Braden dont worry working on harold too

[Bodkins]

Been thinking about what is getting this great setup running,
I guess its the potential difference of the ground. I have had this happen before with the fan in oscillation, pumping the HV out then switching off, you are left with a Suction action in the circuit.
The great thing is Aromaz has worked out a way of triggering the system with the planet. I have found that i can remove the 2222 transister and go into the first Base with the ground. After the first pulse with I start the system will trigger itself .Also when i say ground I can mean Aether because the equilibrium needs to be restore in the system(cheers Braden)And the aether needs to do that Or the ground.
Once this starts to happen it will continue to happen that why nat had 600 volt coming into the system and Aromaz had a voltant increase and or a system running on next to nothing.
Well That What I Think(Hope) is happening.
Take Care B
ps.Got More scope shots coming with a Three dimensional Wave will upload tomorrow.
Thanks Aromaz

YouTube - Bodkins 30 Aromaz rep3.AVI