Making blank water

[Aaron]

diesel

Hi Jetijs,

Can you try it with Diesel?

Another thing to try it with is water soluble machine shop oil. This is probably the best stuff to use to emulsify water...and has been proven to run an engine more reliably than any of the others I believe. I'm not sure what ratios they used though. There is quite a bit online about it.

Try the same ratios that you did with the gasoline and compare what is the most promising.

[Jetijs]

Aaron, will try it on diesel tomorrow.
I have this water soluble machine shop oil. I use it to cool down the end mill bit on my cnc router and also to wash away metal chippings from the milling area. It is great, because it lubricates the work area and prevents corrosion of metal parts. It mixes with water very good. I tried adding gasoline to this water/oil mix, but it would not mix, it always stays in layers (gasoline on top of the water/oil mix). Will try this on diesel as well.
Thanks,
Jetijs

[DavidE]

Jetijs

After reviewing Emoto's work with water... simplistically, water appears to have characteristics like a sink or capacitor for adopting the local predominant frequency.

They experimentally demonstrated through focused will (thought) of a group, that they could change resultant properties of water.

I am not convinced that there is such a thing as "virgin water" because no matter the form of H20, nesting frequencies of location would almost certainly have some residual effect.

Its like asking where might it be absolutely quiet? Well, frame of reference would suggest quiet is at an x/y spot, but on either side of this limited location... the universe be rockin.

I believe the only limit to transmutation of waters organization/structure, is the purity of its environmental (surrounding) frequency. This, being a prevailing force kind of conversation.

In fact, I have always wondered if "water" surrounded by strata (earth composition) that resonated at a certain frequency, may be the cause of pools of subsurface oil.

[Vortex]

Spin

This could be helpful,
More info about spin/spin.

I tried the experiment dealing with the transfer of alcohol-information into water and it worked properly. Generator of Axion Spin Field -- Experimental Results

Attention! Thus, probably, water can be both "health-giving", and "unhealthy"! Excitation of "Axion (Spin) Field" in Water

Above two found at Source of above: Studies of the Spin Field and the Torsion Field
(c) Robert Neil Boyd

Randy

[Aaron]

diesel engines

Another thing to try it with is water soluble machine shop oil. This is probably the best stuff to use to emulsify water...and has been proven to run an engine more reliably than any of the others I believe.

I should have mentioned that this was done on diesel engines.

[Aaron]

synchronicity

[quote=IndianaBoys;37998]

Jetijs,

In Johann Grander's book On the Track of Water's Secret...in the back by some scientist..can't recall name off hand...had a great explanation of how homeopathy works. Very interesting!

Aaron, it is a good reference and starts back on page 161.
It is Dr. Felsch.

Searching Google on this topic this interesting subject was located:

Reflection of Mind Projected Thought into Water Photographed

LAB NOTES

Great topic,

IndianaBoys

WHOA
Big synchronicity!

This is about the Lab Notes page and that letter G.


Check this out:
http://www.energeticforum.com/psychi...tographed.html

[Tishatang]

Hi All,

Video here to mix oil with water with Ph of 11.5 using electrolized water only.

YouTube - How To Melt Body Fat ~ Drink Kangen Water

These units expensive. Must be a cheaper DIY way?

Interesting link here on water that purifies everything. Old paper, what happened, or just BS?

https://www.arashi.com/pipermail/scp...q4/000535.html

Tishatang

[Jetijs]

Just tried the trick with diesel - does not burn, the effect is just the same as when mixing distilled water with diesel.

[DavidE]

Benveniste: transmitting homeopathy by wire
Benveniste's Digi-bio claims

I just heard a short presentation by "water memory" researcher Dr. Jaques Benveniste (at conference SSE 18th, 6/5/99). He claims that the "structure" of biochemicals can be impressed on water electrically using white noise and coils, and then the water will display some of the activity of the original biochemical. See DigiBio Research Laboratory. His experiment is fairly simple:
- wind two coils around a test tube containing a water solution having a particular biochemical. Benveniste mentions using "telephone pickup coils" taken from those suction-cup things (maybe the ones from Radio Shack? I know Tandy/Radio-Shack in Paris.)
- play white noise into one coil, sense the modified white noise via the other coil. A sort of "water-core transformer," with the water containing the chemical being studied.

- transmit the "modified" white-noise to a distant location (or record it, then mail the recording to the distant location, or send it as a digitized .wav file over the internet.) Bandwidth must be about 22KHz, perhaps lower.

- at the distant location (where cross-contamination is unlikely) play the modified white-noise signal into a coil that's wrapped around a test tube full of pure water. Shake the tube during this process, otherwise the water supposedly won't "record" the pattern reliably.

- test for presence of the original biochemical. See if the pure water will cause appropriate reactions in sensitive bio-materials.

- alternately: play the modified white noise signal into a coil wrapped around the bio-sensitive material itself (such as a lab animal!) and see if it has any effect.

From memory (so might not be totally accurate) :
He found that a standard test for staphlococcus would respond to "white noise treated" water as if it had a certain chemical in it. Also, guinea pig skin capillaries responded to an acetylcholine "treated" water by a visible dye response. Also, live guinea pig hearts responded to another type of "treated" water as if a chemical was actually present.
One problem: his tests rely on highly sensitive chemical reactions which are triggered when trace amounts of certain materials are present. The "signals" impressed on the water give a reliable but WEAK effect. I was wondering if the signal for alcohol could be impressed onto water, and then the signal could be played into a coil wrapped around a human body to cause intoxication. If the effect is tiny, this wouldn't work.
Scary thoughts: some tiny chemical concentrations have very large results. Play the white noise through a bottle of LSD, then send it into a coil wrapped around a human body. Will the signal cause the same reactions as if traces of the actual chemical were injected into the person? What if we amplify the signal and apply it to a very large coil? Would everyone in the vicinity trip out? Play the signal into the power lines and affect the population of an entire city? What if we use nerve toxin instead of LSD...

Speculative weirdness: wind the two coils around a human head, play the pure white noise through it, then send the resulting signal into a coil wrapped around ANOTHER person's head. Like bad 1950's sci-fi movies! would we get telepathic communication? Or would the personality of the "transmitter brain" overwrite the personality of the "receiver?" Repeat the experiment using a human and a duck, or use a fresh corpse, Dr. Karloff. Or more seriously, can the water microstructure of a healthy person be used to strengthen somebody who's weak and sick? OK, try to transmit diseases or disease-immunity over wires. Maybe cause a developing frog egg to grow up into a chicken? Or can the chemical structure of a youthful body be used to rejuvinate an elderly one? double !


Suggestion: extract the difference signal between the original white noise and the sense coil. Does the difference signal measurably change when various chemicals are passed near the coil pair? If so, then examine this signal with a spectrum analyzer to look for resonance lines associated with various chemicals.

Suggested circuit from Rick Andersen:
An implementation of a system to produce audio frequency "Bio-Holograms"
http://www.tricountyi.net/~randerse/bioholo.htm

[Aaron]

different ratio?

Just tried the trick with diesel - does not burn, the effect is just the same as when mixing distilled water with diesel.

It will probably definitely work at higher ratios. One truck drove across Australia in a race and it was running on emulsified water. 50/50 mix or less, not sure. If I can find the references, I'll post it.

Of course this is much different than transfering the properties of fuel to water.

[Doc]

blank water

Hi Jetijs

I understand your concept but I am not sure if this is possible. The reason is that water is one of those properties that can't be quantified. It has properties like no other material on the planet and is truly unique. I think it has something to do with the negative hydrogen bond which always leans towards the positive, except in the case of the heavy water molecule.

Because water has the ability to retain "memory" the split second it reconforms to water after the HHO process it will restructure itself to whatever it is surrounded by, as if by instinct or a governing law of physics that says it just have to.

This does not mean that it cannot take on new or altered information and if this being the case then one does not need blank water but to only adjust the water that you currently have.

So water is like a painting that can be altered or adjusted, but never to be a blank canvass. It simply has to have memory, any memory.

So if you wanted to have water with the memory/frequency/imprint of sucrose. Then all you do (this is the simple method) is take some potabel water and add a tiny quantity of sugar.
Succuss it (smack it hard against a piece of wood, your hand or something so that you can visibly see a bubble reaction at the surface. Do this a few times. Dilute the water in a 10:1 ratio and carryon with the process.
After about 4 dilutions and processes what starts to happen is that molecular crystals form that take on the frequency of the glucose molecule.
Initially the bonds are weak but at about 6x and higher the energy emmitted by these molecules is extremely strong.

Add a few drops of this mixture to some water and drink and the pancreas will produce insulin immediately.

Before a biological process can occur, there has to be an electrical one first. Electricity governs the biological.

[Jetijs]

Hi Doc
You might be right. Can you tell me what is "potabel water"? Does the "Ssuccuss" method work also with vodka instead of sugar?

[Doc]

potable water

Hi Jetijs

Potable water is another term used for safe drinking water, however in the manufacture of medicines and certain cosmetics the potable water is refined by filtration and guaranteed free of pathogens.

As for the Gin, well it would be like being drunk without the pleasure of doing the deed. Seems futile, would rather enjoy the party.

[amigo]

Hi Jetijs,

Interesting subject, thanks for bringing it up, I have been looking into it (theoretical research) for many months now.

From the research on Viktor Schauberger, my understanding is that in Nature the process of clearing the water memory happens with evaporation of standing and running waters into the air and the consequent percipitation. I guess you could say that Nature "knows" its blood (water) has been contaminated, after it had run above ground, and needs to be purified.

On the other hand, Nature structures the water by filtering it and pushing it through various layers of the Earth and once the process is complete (again Nature "knows" when it's ready), the water surfaces. It does this usually in the forests under the shade of the trees and away from the Sun which causes it "harm" (by heating it).

This kind of water is prime and ready to be used (consumed) after it has been infused with characteristics of all kinds of minerals and elements it had come in contact with during its trip through the Earth.

Once on the surface, Nature will provide the system for keeping this water fresh for as long as nobody (humans) interferes with it. The system of meandering streams and rivers provides for a natural way of cooling the water while in the Sun, using vortex principles.

Absolute must see video is Callum Coat's Sacred Living Geometry which has a ton of information on water in general and in Nature, vortices, etc.

Now, in theory (I have not tried it yet) I believe that artificially structuring water could be accomplished through implosion, by running the water through a votex of specific geometry, as it is done in Nature, just on a smaller scale.

Some have followed this trail of thought in the past and there are couple of videos on YouTube about producing structured water by using a home blender and couple of magnets. Obviously, the blender is not creating an ideal geometry of the vortex due to its shape, thus the need for weak magnetic fields using the magnets to force the process.

Technically this would cluster the water molecules and change the geometry of the whole thing. Afterwards it should be ready to be impressed with whatever new memory ones wishes to use.

Since there's always more than one way to skin the cat, as they say, others claim that structuring water can be accomplished simply by keeping a weak magenetic field around it. Many have tried experiments where they would use fridge magnets and put them under the glass of water, or some other liquid (all liquids contain water after all), and observe changes in taste compared to the control sample.

To me this sounded too simplistic to actually work so I never tried it. I was always concerned that intent of the experimenter would mess in some way with the outcome of the process. Although if we approach this from another angle, one could say that intent is imperative because everything is connected (as one).

Perhaps my previous thinking that experimenter would mess with the outcome is flawed because we are not, and could not be detached from the rest of our environment and are all as one, therefore explaining how intent causes an effect in the first place.

Regarding your experiment with distilling the water using aluminium and stainless steel, I suggest you look up traditional means of vapour distillation, as they are done in the chemistry labs using glass equipment (heating one container, running the vapours through a condenser and collecting the evapouration in another container).

Needless to say you have to have impecably clean equipment to achieve medicinal grade Distilled Water (DW), but close approximations of the same is possible at home too. Surplus stores might have the necessary lab equipment (borosilicate grade glass that can be heated with this purpose, the double wall condenser, rubber and glass tubing and valves, etc.)

Or you could always try to purchase some DW from a medical supplier and skip the whole process altogether. Although there's the issue of structuring that water, because even medicinal grade DW you buy has been around the environment long enough to absorb some of the external influences.

I'm gonna stop now before this post becomes a short novel !

Oh...before I forget

@DavidE

Regarding magnetic coils on the head, you might wanna look up Dr. Persinger and his "god helmet"...

[Jetijs]

Hi amigo
Great post!
I am awaiting the second part of your novel