Aromaz Radiant Energy Joint Research Group

[Aromaz]

Excitement

Morpher44; now I can see you mind radiating!

Yes, you are right. Argon is a very interesting gas to receive energy.
I did some experiments with it, have many here in my steel workshop for 'free'.

But Argon can not generate magnetic 'force' or influence other minerals;
at least to what I found to date. On the other side, the heavy gas of mercury vapour does that. Pulsed mercury vapour created instability in copper wire = electric current.

I packed all up for the moving to my new dedicated lab.
Will do more intense work on this setup there.

[sucahyo]

In my videos 22/23 I was using a fluorecent tube with HV pulses which is picked up by the copper wire coil around that tube - and in fact has higher energy than going into the tube.

So far I did experiments and found that I get the same with mercury vapour in a normal glass tube - thus eliminating all the other gas components.

I currently halfway reading Keely's book. Have you tried tube contain all mercury which is half vapor and half liquid? I think this require delicate control of temperature and this maybe the reason of why a vimana need a furnace to heat the mercury inside the ball.

What kind of pulse that you used? have you tried pulse driven by three frequency mentioned in Keely's book?

Congratulation for the company, I wish it would be succesfull.

[Aromaz]

I currently halfway reading Keely's book. Have you tried tube contain all mercury which is half vapor and half liquid? I think this require delicate control of temperature and this maybe the reason of why a vimana need a furnace to heat the mercury inside the ball.

What kind of pulse that you used? have you tried pulse driven by three frequency mentioned in Keely's book?

Congratulation for the company, I wish it would be succesfull.

The Vimana's (is said to be) use solar heat for vapourizing mercury. At 1 athmosphere mercury vapourize from about 35 degree C. If in vacuum - off course the flashpoint is much lower; the same to the other end of the scale - higher pressure; higher flashpoint.

I pulsed with air valve; open to release presssure into glass tube. For experiment I wanted slow frequency. On the end I had a vacuum pump with three tier sump and ice for cooling mercury back to fluid.

[sucahyo]

The Vimana's (is said to be) use solar heat for vapourizing mercury. At 1 athmosphere mercury vapourize from about 35 degree C. If in vacuum - off course the flashpoint is much lower; the same to the other end of the scale - higher pressure; higher flashpoint.

I pulsed with air valve; open to release presssure into glass tube. For experiment I wanted slow frequency. On the end I had a vacuum pump with three tier sump and ice for cooling mercury back to fluid.

Thanks. Keely mention he getting energy by disrupting balance of liquid and vapor with sound. I guess using electricity may achieve the same thing. He use silk wire to transfer the energy to convert water to very high pressure gas.

There is a vimana engine design where the ball is put on top of ring of fire which must be lit/heated up to start the engine.

This made me remember thehulleffect topic where HV transfered to rotating oil made the car magnetized. I guess similar thing can happen on mercury.

Would liquid mercury have the same conducting property as vapour? Can mercury react to magnet the same way as homopolar motor do?

[Rectified]

Intelligent Discussion continue

Aromaz it’s good to see your still around
I can’t wait to see your lab up and running. The direction you are pursuing is needed and overlooked by many. Mercury like the discovery of the laser, seems to take far to long to utilize to its fullest potential in other ways.. Many fail to utilize all the properties of an element once one is found very useful for one purpose, their other valuable properties are forgotten. The diamagnetic properties of Copper for example, is seldom thought of in most calculations, just its use as a hi-way for electrical energy and its resistance. Bismuth is the most diamagnetic of all metals and exhibits the lowest thermal conductivity of any metal, except for mercury. Bismuth is one of few metals that increase in volume upon solidification, where it expands 3.32% when changing from the liquid to the solid state. Yet its beneficial properties in magnetic devices has yet to be used by many.

It’s good to see an intelligent discussion continuing on this thread. Unlike another thread I just read, I could hardly believe. It seems like they are content with being told what to say and how to do everything they are told, playing follow the leader copying what someone else has done. Like good children they are told they are not allowed to even mention Tesla in any discussions. What? It seems they rather play show and tell without allowing any discussion that may lead to another possibility of what might really be a valid explanation for their outcome afraid their leader will take his toys and leave if they dare consider what else could be an explanation.

I commend Aromaz and other on this thread for keeping this a civilized place where we can chair opinions with an open mind. When we allow others to dictate what we must believe as fact and no other explanation possible other than his, they will never find what they need to learn. Like most dictators his day will come where is followers will learn they where mislead.

Rectified

[Aromaz]

@Rectified; I stand humble for your possitve comments.

Yes, Bismuth has been on my list; but in Thailand I could not find any supply - yet.
Surprisingly I found ample supply of Cobolt. They say in Thailand you can get anything - l hope I can get some Radium or Thorium too - soon.

Your comment ragarding Copper is very valid - and it is the same diamagnetic properties I am 'investigating' in the mercury.

I do have a big flaw: I never like to follow (Or copy other than to learn properties).

[Inquorate]

Copy cat

Hehe, I'll copy anything to observe anomalies. the exception to the rule proves the rule.

'that thread' has taught me much

Ultra wideband electromagnetic waves coming from a chaotic oscillator could very well mimic the same aetheric condition that (truly random) radioactive decay causes.

Throw in an avramenko plug made of tesla-esque 'diodes' (the 1n4148's are only good up to 500mA) like my magnetic diode, or charged capacitors...

and one could scale up the entire system..

viola, one system pertains to the other.

What I want is a chaotic oscillator, and I'm looking into RF systems.

Love and light

[Aromaz]

How does a transformer work?

Now, this is not the question that wants an answer like:
Number of primary windings around mutual core with number of secondary windings gives x-ration which is y-volts.

I would like to know if anybody really figured out in practice WHY is it that 10 primary windings at 1 Vac with 100 secondary windings on ferrite core gives you nearly 1,000 volts? Or why does 50 primary windings with 25 secondary windings gives you half the input voltage.

What is the exact method taking place? It can not be 'volume' because the same 100 primary windings can be of thicker gauge and weigh 100 grams, where the secondary windings is of thinner gauge and still weights 100 grams.

If we take the same ferrite core, give the primary 10 turns and the seconday 1,00 turns, bi-filar; then we end up with two secondaries each still giving 1,000 volts.

Yes, I also know it is all to do with magnetic flux - but the exact method of reaction puzzles me.

We know it is directly related to the NUMBER of turns, no matter size, volume or any other. But how does that science actually take place?

To rephrase the question:
WHY is it that 1x turn = 1x volt and that same 1x turn will yield 2x volts in another coil on the same core which is 2 turns. Why does the turn create the volt?

Would one be surprised to discover later that a volt is in fact also some kind of pulse? Say 1 volt = 1 mil pulses, but since we can not measure a millionth pulse, we can only measure it is groups of million pulses?

Something else of interest, related to numerology:

Amp = A = Alpha
Volt = V = Can be Roman number 5, but is also 5th last in our alphabet
Ohm = Ω = Omega

Accidental?

[rave154]

Damn Aromaz, youve got me thinking here.......illl be up allnight at this rate......oh wait......im already up all night

[Inquorate]

Um

@ Aromaz - interesting question.

I've been thinking of how to make a gaussmeter on the cheap since I read your question.

Ps I like the idea of tiny divisions of a volt idea.

Here's my idea, you'd have to be able to adjust the sensitivity somewhere and hook it up to a millivolt meter or something for a strength reading.

Build this simple "electronic electroscope," a FET electrometer

But replace the field effect transistor with a hall effect transistor

UGN3503U Hall Effect Sensor - Jaycar Electronics

Which would show the magnetic field's strength as volts.

On an Oscilloscope you would see the rate of change of the magnetic field and could see it's relationship with voltage current and turns.

Maybe try flat copper wires etc..

It's the rate of change that is interesting, as this causes the current as voltage per turns.

But I've got my hands full, can't take on any more experiments (unless you share really interesting results of course)

Love and light

[Inquorate]

Could it be so simple?

Length of the wire, not the turns.

Come to think of it, I've never seen a transformer core with a changing or multiple diameter.

[sucahyo]

To rephrase the question:
WHY is it that 1x turn = 1x volt and that same 1x turn will yield 2x volts in another coil on the same core which is 2 turns. Why does the turn create the volt?

Difficult question. phase relation?

Consider 1x turn primary receive a 360 degree current sine wave with 1x volt at 1T. A 2x turn secondary will forced to produce a 360 degree current sine wave in 1T at 2x length. Stretching the current phase reduce it's current and increase it's voltage, to produce 2x voltage.

[morpher44]

Ankh Detector

YouTube - Ankh Neon Detector

[Aromaz]

YouTube - Ankh Neon Detector

Interesting, what would be really nice is if you can expand a bit and re-design to make the neon also a 'directional pointer' so you can use it to actually see from where the energy flow comes. Maybe something like a mini sat dish or cone? Shield the neon in such way that energy can only enter directional?

In relation, I did another experiment which I never published yet. Should do. I pulsed HV output from the coil through a Cadeseus coil and then determined the output with LED in hand. Some areas were very high(100cm+), some even as near as 1 cm no result. But I did not get as far as making the neon completley directional.

[morpher44]

loop geometries

Interesting, what would be really nice is if you can expand a bit and re-design to make the neon also a 'directional pointer' so you can use it to actually see from where the energy flow comes. Maybe something like a mini sat dish or cone? Shield the neon in such way that energy can only enter directional?

In relation, I did another experiment which I never published yet. Should do. I pulsed HV output from the coil through a Cadeseus coil and then determined the output with LED in hand. Some areas were very high(100cm+), some even as near as 1 cm no result. But I did not get as far as making the neon completley directional.

@Aromaz

Yes a directional detector would be interesting.
There is a "scalar wave detector" thread here discussing those
sorts of ideas ...

In messing around with this, one thing I did notice, days later,
is that my hand (only my right hand) has skin that
is completely dried up -- as if my hand was sun burned.
The skin feels all rough and dry. This did not occur to my
left hand (which I was not using in these fields).
The frequencies from your self-oscillating circuit, when used
with the auto ignition coil, are down in the 3.8Khz - 6khz range --
quite low. But the Joule's of energy in these fields is quite high ..
and it gave me quite a nasty dryness in my hands.
This from only a couple minutes of exposure.

So like Michael Jackson, it might be wise to wear a sort
of "metal glove" of your right hand (or left hand),
when messing around with these fields.
You don't feel it when its happening ... but days later your
hands are quite dry and irritated.
So the energy is there... in these fields.

The cylinder wrapped with a foil capacitor produces a very
LARGE field. I can bring this Ankh detector around a sphere
that has a radius about 1/2 meter or so ... and I'm not
necessarily at resonance. Just near it.

The loop of wire, for best detection, however, needs
to be placed so that the plane of the loop interfaces with the
surface of the sphere. If you rotate the loop off of that
surface, and have it at various angles ... there is less
of an inductive pickup.

Also, if you take the straight wire and connect it to a longer lead
say, and then bring that lead gradually toward the loop
of wire, the neon still glows. But when you intersect the plane
of the loop, you can dampen and then extinguish the glow.

I think in terms of BEAMing energy unidirectional, yes you would
need a geometry that lends itself to a beam ... such as a dish.
With a dish shaped capacitive emitter .. you might achieve
farther distances.
And ... going scalar (longitudinal) ... or smoke ring shaped waves ...
if possible (and real) would be way cool.

Metaphysically people are trying to create chi-balls with their
hands ... and throw them. If this is possible with Chi ... it
should be possible with electromagnetic phenomenon --
if the universe works as conventionally thought.

PS> Does anyone know if the ANKH loop uses PHI/Golden Ratio?

--morpher44