High Voltage from Thin Air?

[rave154]

Dr Stiffler,

you may want to use "Super Anti Spyware", its absolutely THE BEST program of this kind ive seen ( it found and got rid of a nasty that id got that had me on the brink of junking the entire PC ), its free ( home edition ) no restrictions...it finds em and kills em.

SUPERAntiSpyware.com | Remove Malware | Remove Spyware - AntiMalware, AntiSpyware, AntiAdware!

when running it do a "complete scan"

[DrStiffler]

@Dr. Stiffler
I put together (as best I could) a replication of your latest video where you show a feedbck loop off the S Gate. I used my SEC 15-3 and frankly didn't expect to see anything happen. It appears to work and I tested it with a few caps to see if the meter was wrong or if the amp draw was really that low. This setup might be all wrong but this is about as close as I have gotten to a self runner.

YouTube - Dr. Stiffler SEC feedback experiment ---my replication.ASF

Thanks for sharing.

Lidmotor

@lidmotor
Have yet to view your vid, but will try here to upload a hand drawn diagram.
I was not expecting anyone to do it..... If I can't upload the image, will do one late tonight when back at the lab.

*The diode from +v to exciter, connect sgate diode to battery side for charge and to exciter side for low current run.

[Lidmotor]

Dr. Stiffler's ULC Exciter

@ Dr. Stiffler
Thanks for the quick info on the correct circuit. I did not get it quite right but I was close. On my setup I kept the two coils serperated and fed the S Gate through the air. I will try the correct way and see what happens. This reminds me of what we have done before in terms of feedback but I like that you are using the S Gate again. Long ago, when I first started working with your circuit, it was an S Gate experiment that really got me hooked on your work. The experiment was the one where you attached a 110 volt filament night light bulb to the gate by only one wire. My attempt at the experiment appeared to not work ---until I turned the lights off and there it was glowing dull red. The circuit was completely open ended but the filament was glowing. I showed my wife and she didn't understand what it meant---but I sure did.

Lidmotor

[DrStiffler]

@ Dr. Stiffler
Thanks for the quick info on the correct circuit. I did not get it quite right but I was close. On my setup I kept the two coils serperated and fed the S Gate through the air. I will try the correct way and see what happens. This reminds me of what we have done before in terms of feedback but I like that you are using the S Gate again. Long ago, when I first started working with your circuit, it was an S Gate experiment that really got me hooked on your work. The experiment was the one where you attached a 110 volt filament night light bulb to the gate by only one wire. My attempt at the experiment appeared to not work ---until I turned the lights off and there it was glowing dull red. The circuit was completely open ended but the filament was glowing. I showed my wife and she didn't understand what it meant---but I sure did.

Lidmotor

@Lidmotor
Well again, thank you for your time in trying to replicate my work. Although the video and many of the power circuits I did talk about and show that used the SGATE can only be tuned in the frequency domain. Therefore I dropped all public display of the SGATE because very few people maintain or have access to an SA, which is a must for tuning to get the desired results.

The SGATE is the most effective way to obtain a self running system, but, this does not mean you can totally remove the battery (in some cases). This does not mean that the battery supplies current (sometimes) but means the battery is a fundamental part pf the oscillation circuit. Small multi-farad capacitors one might think will work, yet a battery seems to be an integral part of these systems. Even with the large frame caps like I use, maintaining the Lattice interface is sporadic.

I can indeed post diagrams and instructions, yet it will only be of value to those that are looking to make a profit or in some way capitalize on the work.

If you want to look further, you will need to email me at the lab. Your email addresses were lost in the last reload after a virus attack.

*For all concerned; I only communicate on meaningful research with PGP and 2048 bit encryption. If you can not work with this, please do not ask for communication in this area.

[ABCStore]

Dr.,

could you shed some light on your last videos? Do you imply that no exciter is used at all?..

ABC

[dragon]

Dr. Stiffler, I watched your last 3 videos over and over again and that is simply amazing ! The only thing I'm missing is the L3 coil specs. Could you guide me to these... number of turns, diameter of the form, wire size and/or the uh of the coil.

Thank you so much for sharing... Your so inspiring, I simply have to give it a try.
________
Marijuana medical

[dragon]

Playing with the idea a bit, I wound a 68 turn coil around a .625 form using 26awg wire. Connecting it to the FG and scope it seems to have a very large range of resonance. Disconnected from the FG it picks up the 60hz signal from my CFL lights quite well. I haven't been able to light an LED as yet.
________
Colorado marijuana dispensary

[seth]

@ Stiffler

Wow!

fantastic vids - im new to your SEC ideas so ill be reading the threads and watching your vids and checking the website. Well done and thanks for the clear info. cant believe i've not read this thread till today.

[anonymussle]

Stiffler's simple SGATE and a foxhole radio

Hi all,

Just thought I'd mention that Dr. Stiffler's SGATE is not too unlike a simple foxhole radio.

Mussle

[Armagdn03]

Hi all,

Just thought I'd mention that Dr. Stiffler's SGATE is not too unlike a simple foxhole radio.

Mussle

I have to hear an explanation for this! I donno.....

[conradphd]

Hi all,

Just thought I'd mention that Dr. Stiffler's SGATE is not too unlike a simple foxhole radio.

Mussle

@anonymussle

Great observation! Have you also noted the similarity between Henry Fords Model A and Chariots? I think old Henry should only get credit for removing that dang horse?

[shubhamforme]

new generator cop>9

http://www.energeticforum.com/renewa...tml#post113228


go here and check out the simplest overunity generator the "fleet"
thx

[dave_cahoon]

The battery to me is like the rudder on a boat.
Simply to point the system in "that" direction.

[seth]

I dont know if this is interesting for you guys, but i thought it might be - i dont usually double post but i think the slayer exciter has a lot of similar effects to the various sec devices. And i know you guys are the experts with the sec.

Can anyone explain why i dont get an electric shock? In particular with the third bulb from 1 minute into the vid.

This is all on 15V at 1A

YouTube - incandescent magic with exciter.wmv

Sorry for interrupting - if this is considered irrelevant just ignore it

[DrStiffler]

I dont know if this is interesting for you guys, but i thought it might be - i dont usually double post but i think the slayer exciter has a lot of similar effects to the various sec devices. And i know you guys are the experts with the sec.

Can anyone explain why i dont get an electric shock? In particular with the third bulb from 1 minute into the vid.

This is all on 15V at 1A

YouTube - incandescent magic with exciter.wmv

Sorry for interrupting - if this is considered irrelevant just ignore it

@seth
No, don't think we (I) can help you much, in the 'Joulethief SEC Exciter and Variants' thread, posts #1104-1105-1124 and 1125 may explain why.