Tweet
Self Charging Effect Eliminated After Graphene Power Cell Trial !!
I tried out the last and final candidate to make a self charging cell.
I had purchased a thermal pad graphene sheet. I used graphene,
aluminium and water. I measured 0.7 Volt and around 2 microamps.
No evidence of self charging effect. The technical explanation is
that if it was self charging the amps should have gone up. So just
like the previous cell with copper coin, zinc\iron plug and glue stick
adhesive mixed with natrium salt. It to had too low amps. So my final
conclusion is that the microamps were caused by ordinary common
effects.
Finally i can close my power cell project !! - Kai Anders Wold
I had purchased a thermal pad graphene sheet. I used graphene,
aluminium and water. I measured 0.7 Volt and around 2 microamps.
No evidence of self charging effect. The technical explanation is
that if it was self charging the amps should have gone up. So just
like the previous cell with copper coin, zinc\iron plug and glue stick
adhesive mixed with natrium salt. It to had too low amps. So my final
conclusion is that the microamps were caused by ordinary common
effects.
Finally i can close my power cell project !! - Kai Anders Wold