Joulethief SEC exciter and variants

[totoalas]

L1 outputfor charging same power source???

[QUOTE=Lidmotor;105235]@ Penno & All


I still ask the question: What the heck is going on here with these relatively low voltage circuits that produce the electrostatic effects of a traditional HV Tesla Coil?


Hi to all
To add another question?
Can we add a diode from the output of L1 or another coil rolled in L1 to connect to the positive rail of the power source during operation??????

Ive asked tis question since when i connnected the mini tesla coil without a load for 2hours and the output of L1 1 cm from the positive rail of 12 v car battery
the voltage reading from 12.79 jumped to 12.81 in 2 hours
Update same result batt charge returns to its original value after discharging from 12.63 to 12.72 in the afternoon

Somebody eXplained PASSIVATION IN Grounloop thread so my tests stopped here

cchheers

totoalas

[woopy]

Hi all

just a small update of electrolisis experiment

I tried to put the diode outside the water container.

I made 2 small holes in the container and glued 2 thin stainless steel wire one bent to up and one bent to down. I connected the 1N4148 at the end of the wires and lets go.

Very good electrolisis with 22 volts and 0.85 A.

so the corrosion problem should be away

Than i had some further idea i have drawn but not tested. Perhaps tubing could be better than wire. (Stanley Meyer perhaps)

good luck at all

Laurent

[woopy]

and a small youtube complement

good night

Laurent

YouTube - slayer electrolisis with outside diode

[rave154]

nice stuff there woopy

if you dont have any stainless steel tubing to hand.....you could always try what i did....which was to take two stainless steel tea spoons...and place them against one another with little bits of rubber in between them, positioned to keep them from actually touching.

hope this helps.

[Lidmotor]

Practical use for an exciter---The "Mini" at sea

@All
I took my "Mini" on a sailing trip and tried it out as a practical light at sea. It worked and it proved to me that this technology CAN be put to use and not just be an interesting experiment.

YouTube - Mini Tesla Coil Light ---at sea.ASF

Cheers,

Lidmotor

[synchro]

Screen.

@Woopy,

Maybe try and attach the top wire from the diode to a piece of screen and see what happens!

[totoalas]

Mini Tesla Lighting

Lidmotor

great video and view what a luxury

Hope you can show us the mini Tesla with your previous solar jt combined

Im trying to use a solar cell from calculator to power up a jt into a 12 v 1.2 ah battery

Cheers
totoalas

[muchuanlin]

Well learn it
It would be good to see input output measurements, because if there is an energy increase from the lattice (and the accompanying temperature decrease of excited mass), we know we don't have to rely on the mpsa06, and can possibly excite the field with more Amperage using high power transistors and see if the returns are linear, diminishing or exponential.

[Prio]

Joulethief SEC exciter and variants

To all people researching and experimenting on this thread with electrolysis. A must to read! There are most interesting findings concerning electrolysis in the below mentioned thread. If things are true, I see great opportunities for guys in this thread to join in for successful cooperation. With the brain power of the great people in this thread, success may fall in place for very efficient electrolysis using Joulethief Exiter technology.

The downfalls of conventional electrolysis - and how to fix them

[TanTric]

yellow!

just to show my high power Exiter!

Input: 20V at arround 1.2A (24W) at best, im lightning 240V (15W) fridge's incandescent bulbs wirelessly at small distance, by the time of the video i was with somekind of problem and my performance was decreasing i was not able to find why, but in the first tests, before i made it, i was even able to light a 25W incandescent bulb and the 15W bulbs much more brighter!

at the end i show my small mini tesla with an aluminium pype core, powering a bright led at maybe 1.5/2meters wirelessly!

Enjoy! [YouTube]YouTube - jujusalva's Channel

[slayer007]

In this video I just show the difference with and without the capacitor accross the L2 coil.
When using this with higher voltage the capacitor doesn't have much effect.
But on lower voltage it sure does.

YouTube - Exciter With And Without capacitor

[xee2]

just to show my high power Exiter!

[YouTube]YouTube - jujusalva's Channel

Thanks for the video. Does the plasma leave a burn spot when you touch it?

[TanTric]

...

it is so hot, that you will not hold your finger near more that one second...

i think i have not experiencied burn spots because i just touch it instantly, im not masochist, eheh, its impossible to hold it there, to hot!

now i will try to light incandescent bulbs with 1.5V input to 9V maximum... im working in my super efficient setup!!

hugs and thank you for the feedback xee

[woopy]

@synchro
i tried to add a brush of several fine ss wire on the upper lead of a 1N4148 and nothing on the down lead. And almost no electrolisis. Perhaps i have to add the brush also on the down lead to get balanced charges? Will try this next.

@Tantric

Hi juju nice job. if i see well ,you replaced your L2 coil with a 4 turns of plain copper (a la Tesla coil). Have you problem with heating at the transistor ?. Perhaps can you post a recent shematic ? Thanks and bravo.

@Lidmotor

Nice result for a beautifull boat. Thanks for sharing

@Slayer

Yes no discution. It works very well. I have to find a variable capacitor.

@All

This morning i asked me what could happen if we spread (vaporised) some water directly on the plasma arc at the end of L1, Did somebody tried this already ?
No time to test today as i am a brand new grand father.

good luck at all

Laurent

[totoalas]

Cellfone radiant energy vs Mini Tesla

hi to all.
A cellfone ringtone flasher w/o battery brightly light up at the back cover
and a avrenko led barely lit up

On mini tesla the opposite occurs the avrenko led is very bright while the led flasher barely lit up
That means the avrenko can pick up energy on a ringing cellfone

can convert to trickle charge.....????????

cheers
totoalas





[IMG][IMG=http://img205.imageshack.us/img205/2797/minitesla020810024a.jpg][/IMG] Uploaded with ImageShack.us[/IMG]

[IMG][IMG=http://img27.imageshack.us/img27/4976/minitesla020810027a.jpg][/IMG] Uploaded with ImageShack.us[/IMG]