Announcement

**sucahyo** · 04-28-2010, 06:42 AM

Look a lot like Ted's.

If you are willing to test the each leg combination. Find two leg with resistance. use a neon bulb as tester. tap a 1.5V battery pole with active leg. A correct HV leg should make the neon flash.

**diaboliqu69** · 05-05-2010, 04:07 PM

, I`ve just made this measurements:

pins numbers value

1 WITH 2 12 OHM

1 WITH 3-4 24 OHM

1 WITH 5 35 OHM

1 WITH 6 43 OHM

7 WITH 8 4 OHM

2 with green wire 300 OHM

each coil in other side 2,5 OHM

**sucahyo** · 05-06-2010, 01:18 AM

??? Weird that not one connection has resistance more than 1000?

Here is Ted's

Used instruction from here:
POWERLABS' High Voltage Solid State Flyback Driver

He remove the old primary winding and replace it.

**stevend** · 05-06-2010, 01:08 PM

I did the same thing for mine, rewired the primary. With the type of flyback Jean-Louis is showing you can't do that but with yours you can. I'm pretty sure I used those same instructions from PowerLabs too. Mine's here:
http://rimstar.org/equip/30kv_pwr_supply.htm
-Steve
http://rimstar.org http://wsminfo.org

Announcement

High voltage power source

High voltage power source

Comment

Comment

Comment

Comment