HHO dry cell type water splitting DIY + Q&A + FAQ

[StevanC]

Hi,
tons of posts, already, hate to hijack anyone's thread, really hard working people, great work much effort...

my problem:
how does one begin to end up with a properly sized HHO-e-lyzer?

I made one 6 cell 5mm gap and was a bit dissapointed.

then i currently explore a 10 cell 3mm gap one and I'm just not sure:

Is the dry cell type seen as an inductive load to it's power supply?

I have back-spikes here, oscillations, i had to put a diode to the PWM powerstage to mitigate and yet there are some left?

Best regards,
Stevan C.

[StevanC]

I guess I didn't point out I use a "dry cell" sort of electrolyzer, and not a "smack" type, if that matters.
Are there any advantages in regards Smack vs Dry cell?

[ashtweth]

Hi Steven ,most call this the hydroxy "bible" our community authored it.
check the dry cell designs and FACULTY section of the document.
Panacea University - Courses
->hydroxy course

Also check Patrick's chapter 10
Practical Guide to Free-Energy Devices - Chapter 10

Also check this thread for the open source design
http://www.energeticforum.com/renewa...-dry-cell.html

Ash