Sonofusion Replication and Research

[gravityblock]

I have found an amp that will do the job:

Amazon.com: Sure 4x100W @ 4 Ohm TK2050 Class-D Audio Amplifier Board: Electronics


-Altrez

Reports are abound (on the Internet etc.) that sonoluminescence requires at least an 100/200/300... Watt amplifier. In fact typically only ONE watt is dissipated in the transducers/drive system during sonoluminescence. More "powerful" amplifiers are really only being used to overcome bad matching by brute force, by providing more raw voltage swing - it's not the available power that counts!

Additional Resources:

Single Bubble Sonoluminescence HOWTO

Sonoluminescence: A Star in a Jar, "If the bubble contained deuterium, it would become hot enough to generate fusion if the radius became as small as 10nm."

GB

[altrez]

Reports are abound (on the Internet etc.) that sonoluminescence requires at least an 100/200/300... Watt amplifier. In fact typically only ONE watt is dissipated in the transducers/drive system during sonoluminescence. More "powerful" amplifiers are really only being used to overcome bad matching by brute force, by providing more raw voltage swing - it's not the available power that counts!

Additional Resources:

Single Bubble Sonoluminescence HOWTO

Sonoluminescence: A Star in a Jar, "If the bubble contained deuterium, it would become hot enough to generate fusion if the radius became as small as 10nm."

GB

Thank you for the post gravityblock!

Yes I have read that the reason for the amp is to overcome some flaws. However I want to be as successful as I can be on my first go around then fine tune the chamber after I generate my first star.

Thank you so much for the links I will add them to the first post!



-Altrez

[altrez]

Hello Everyone,

Just wanted to share that the glassware is on order an should be in this week!

Plan the first test in May.

-Altrez

[Slovenia]

Bad Link (http://whoisyourcreator.org/assets/PDF%27s/sono2.pdf)

Hi Gravityblock,

The link, http://whoisyourcreator.org/assets/PDF%27s/sono2.pdf, is bad and I'd sure like to have that pdf file and look at there other files. Can you make that happen or do you have a copy of the pdf I can have? Thanks!!

Best Regards,
Slovenia

Reports are abound (on the Internet etc.) that sonoluminescence requires at least an 100/200/300... Watt amplifier. In fact typically only ONE watt is dissipated in the transducers/drive system during sonoluminescence. More "powerful" amplifiers are really only being used to overcome bad matching by brute force, by providing more raw voltage swing - it's not the available power that counts!

Additional Resources:

Single Bubble Sonoluminescence HOWTO

Sonoluminescence: A Star in a Jar, "If the bubble contained deuterium, it would become hot enough to generate fusion if the radius became as small as 10nm."

GB

[Slovenia]

sono2.pdf file

I found that sono2.pdf file at another download site.

It can be downloaded at: PDF - Sonoluminescence: the star in a jar (2.7 M) PDF Download

[altrez]

My glass came in broken so I had to send it back ;( In other news I will post some video an pictures of the parts I have put together so far soon. Its really neat. I think I might have already hit the right power level using a light bulb

Lots more to come!

-Altrez

[rough_rider]

sonofusion replication and research

I have been working on a sonofusion system for the last 4 years. Slacked off until I atttended the conference last November. Just about caught up on about 1K pages of posts. Thanks to Aaron et.el. for the work
I put 4 transducers on a bottle but other than the 28khz for the sonoluminescence what second frequency. Ran into Aaron and his book and energetix forum and M J Nunnerley VHF and UHF heterodyning of water vapor (why 1:6 ratio). Trying to catch up and will post some of my findings. First the best overview on heterodyning is :"Development of a variable frequency heterodyne sonication system" by bhanu kiran korremula, 2004, a thesis, free download.

A cheap AF 250W amplifier up to 30KHz is sold by radio shack for less than $200, I found a small variac had the right inductance to match the Channel Ind. Crystal. Off to Yoga. Jim

[altrez]

I have been working on a sonofusion system for the last 4 years. Slacked off until I atttended the conference last November. Just about caught up on about 1K pages of posts. Thanks to Aaron et.el. for the work
I put 4 transducers on a bottle but other than the 28khz for the sonoluminescence what second frequency. Ran into Aaron and his book and energetix forum and M J Nunnerley VHF and UHF heterodyning of water vapor (why 1:6 ratio). Trying to catch up and will post some of my findings. First the best overview on heterodyning is :"Development of a variable frequency heterodyne sonication system" by bhanu kiran korremula, 2004, a thesis, free download.

A cheap AF 250W amplifier up to 30KHz is sold by radio shack for less than $200, I found a small variac had the right inductance to match the Channel Ind. Crystal. Off to Yoga. Jim

Thanks for the post Jim!

I was thinking about using a variac to handle the inductance an now you have confirmed that it will work!



Thanks!

-Altrez

[altrez]

Hello everyone,

I have been working close to 80 hours a week so I have only managed to work on my project a few hours over this month. However I have had a few good test runs and will post some pics of my setup.

I have got my control circuit built an ready and it seems to be working fine.

More to come soon

-Altrez

[altrez]

Update!

I finally had a day off so I though that I would post this pic. I am finally done with the driving circuit! And best of all it works! I am planing on taking some vacation time soon to finish this up

-Altrez

[Felix_the_cat]

Forgive my ignorance but what's the purpose of creating all that?
Is it to make hydrogen?

It reminds me of that mormon guy with his water sphere that was able to boil a gallon of water in a few minutes with only a 9v battery as a power source.

He said he used custom cut quartz transducers and it used sound frequencies. He also said its possible to make hydroxy or electricily using basicly the same technique...

[altrez]

Forgive my ignorance but what's the purpose of creating all that?
Is it to make hydrogen?

It reminds me of that mormon guy with his water sphere that was able to boil a gallon of water in a few minutes with only a 9v battery as a power source.

He said he used custom cut quartz transducers and it used sound frequencies. He also said its possible to make hydroxy or electricily using basicly the same technique...

Hello Felix_the_cat,

My goal is to achieve desktop Nuclear fusion. Sound is a very interesting thing. It can boil water and even melt steel.

Sonofusion is one possible way to create all the clean power the world would ever need.

I started down this path after reading this book:

Nuclear fusion by inertial confinement: a comprehensive treatise
By Guillermo Velarde, Yigal Ronen, José María Martínez-Val



-Altrez

[Oneminde]

Good tread altrez, I'll be following it.

[katiyar_a]

Hi Altrez,

I am Abhishek from INDIA. I am more interested in your experiment than you might be. We are a power hungry and starved country.

Your picture of set-up is good, but small, Can you post some more detailed pics? Any further progress?

Abhishek

[altrez]

Hi Altrez,

I am Abhishek from INDIA. I am more interested in your experiment than you might be. We are a power hungry and starved country.

Your picture of set-up is good, but small, Can you post some more detailed pics? Any further progress?

Abhishek

Hello Abhishek,

Yes I will be posting more pics soon. That is just a pick of my small home lab. It has most everything I need. However I do have access to a much larger space when it is needed.

I am making tons of progress. I am looking into a neutron detector right now: Catalogue - neutron dosimeter - Bubble Technology Industries - (Version JPG)

And have found some very interesting effects when sound is used with neos water and glass. I work two jobs right now so its taking a while to get everything tested.

I have noticed that different types of glass produce heat when hit with the right frequency I find the effect interesting.

If in fact I can produce enough neutrons then once captured they do produce power. At that point its simply finding the right combination. Oh and there is also the strange transmutation effects on different type of elements exposed to this process that needs years of study IMHO

I would like to also state that again this is not a free energy or Over Unity device. Its Nuclear science, that produces a viable clean power source.

Take Care,



-Altrez