Harvesting Energy From the Sun Using Crystals

[MonsieurM]

Hey guys, i found some interesting bit of info on "Captured lightning" in Acrylic, and for the pleasure of the eyes, i included some pics

Captured lightning: The artist who traps 'fossilised' bolts of electricity inside acrylic blocks | Mail Online

Mr Hickman, 62, from Woodridge, Illinois, explains: 'To create our sculptures, we rent "beam time" on a 5million volt particle accelerator.

'As the accelerator injects huge numbers of electrons inside a clear acrylic plastic specimen, a huge electrical charge (typically 1 - 2.5 million volts) builds inside.'

Mr Hickman explained that he manually creates an escape route for the charge - a weakened path through the acrylic.

The charge suddenly escapes in a brief, lightning-like discharge - causing a miniature 'lightning storm'.
The intense heat from this 'lightning' creates branching patterns that have been permanently captured within the plastic.
The patterns are a 'fossilised' chain of microscopic fractures and tubes that reflect light like microscopic mirrors.
The phenomenon is named after German physicist Georg Christoph Lichtenberg, who recorded the patterns in 1777.
The 'Captured Lightning' sculptures are available online for between £17-£299.

[MonsieurM]

in this website, What are Lichtenberg Figures, and how are they Made? ;i was reading through the reference and i found the following papers:

Yu.N. Vershinin, S.V. Barakhvostov, "Electron Processes in the Pulse Breakdown of Solid Dielectrics"

ABSTRACT.
Physical processes leading to formation and spreading of pulse
discharge channels in solid dielectrics were analyzed. It was
shown that the mechanism responsible for appearance of the
primary discharge channel in the near-electrode region (both at
the cathode and the anode) of a dielectric was due to electronthermal
processes. The solid-melt phase transition took place in
the dielectric within the primary channel. This mechanism also
dominated on subsequent spreading at a subsonic velocity
during the cathode discharge. The mechanism responsible for
transformation of the primary channel to the main channel
during the anode discharge was determined. The spreading rate
of the channel always exceeded the sound velocity. Experiments
showed that the spreading was accompanied by processes
characteristic of the detonation effect. Analyzing specific
features of those processes, the corresponding mechanism was
identified as electronic detonation. Physical models of the
processes were proposed. Relations were calculated from
conservation laws in terms of the electric-hydrodynamic
approximation. They were used to establish for the first time a
mutual quantitative dependence between the voltage pulse
parameters, space-time characteristics of the discharge,
thermodynamic and electro-physical parameters of the material
behind the phase transition front and individual properties of
dielectrics.

------
ELECTRON PROCESSES IN THE PULSE BREAKDOWN
OF SOLID DIELECTRICS

http://www.science.az/physics/lab29/...06/eem/c73.pdf

Abstract. Electric discharges with low current densities can be described by a minimal
model of reaction, drift and diffusion of two charged species coupled nonlinearly to
an externally imposed electric field. The intrinsic ionization–field–coupling of the model
leads to pattern formation both in stationary or periodically driven barrier discharges
and in transient streamer discharges. In particular, we discuss negative streamer discharge
fingers extending into a non–ionized area. They belong to the class of Laplacian
growth phenomena. For quantitative predictions, a systematic derivation of the corrections
to the velocity of a moving boundary due to curvature or relaxation effects is still
missing. This is because negative streamer fronts are so–called pulled fronts, for which
standard approximation schemes fail. We present new approaches and results.

and the following one explores the subject of Coral Growth (ie: Coral Castle )

http://www.cse.nd.edu/~izaguirr/jaap.pdf (could not copy the text so i took a pic )

[MonsieurM]

Now, the following website is just plain awesome : i'd recommend to anyone to check it out

"Theo Gray's Mad Science: Experiments You Can Do At Home - But Probably Shouldn't"

Mad Science by Theo Gray

here are a few subjects he shows you how to do:

Trap Lightning in a Block
Seeing the Subatomic
Ignorance = Maglev = Bliss
Metal's Hidden Treasure
Save a Snowflake for Decades
Making Silicon from Sand
Odd Coupling
Uncovering a Natural (Magnetic) Attraction
Atom and Eves

chilled superglue turns solid with even the tiniest amount of water (i remember in this forum glue battery was discussed ), so you can create a lasting cast of individual flakes. Ever wanted to catch a snowflake and keep it forever? You can. This is a photograph of a snowflake that fell in January 1979, but it isn't a 30-year-old photo.

Turn dirt into the building block of every computer-and make an attractive fireball. The industrial economy may someday run out of one of its essential natural resources, oil, but at least the high-tech economy is safe in its supply of silicon, the element that is the key ingredient in every computer processor.

Its oxide form, known as silica or quartz, is dirt common. In fact, it is dirt: Almost all kinds of sand, clay and rock contain silica in one form or another, and overall more than half the Earth's crust is made of silica.

[MonsieurM]

Guys, for those of you who watched the Water Documentary, about capturing various snowflakes that reacts to different stimuli (thank you, i hate you, i love you, classical music, heavy metal etc...)

chilled superglue turns solid with even the tiniest amount of water (i remember in this forum glue battery was discussed ), so you can create a lasting cast of individual flakes. Ever wanted to catch a snowflake and keep it forever? You can. This is a photograph of a snowflake that fell in January 1979, but it isn't a 30-year-old photo.

[MonsieurM]

Now, the following website is just plain awesome : i'd recommend to anyone to check it out

"Theo Gray's Mad Science: Experiments You Can Do At Home - But Probably Shouldn't"

Mad Science by Theo Gray

here are a few subjects he shows you how to do:

Trap Lightning in a Block
Seeing the Subatomic
Ignorance = Maglev = Bliss
Metal's Hidden Treasure
Save a Snowflake for Decades
Making Silicon from Sand
Odd Coupling
Uncovering a Natural (Magnetic) Attraction
Atom and Eves

chilled superglue turns solid with even the tiniest amount of water (i remember in this forum glue battery was discussed ), so you can create a lasting cast of individual flakes. Ever wanted to catch a snowflake and keep it forever? You can. This is a photograph of a snowflake that fell in January 1979, but it isn't a 30-year-old photo.

i fould the page where glue battery was discussed

ice shaped glue battery (fractal ice shaped glue battery ), how about that

http://www.energeticforum.com/renewa...e-battery.html

[MonsieurM]

Dave , the above mentioned method could be applied to your smith coil experiment to visualize the magnetic field , and to an smal ice block that has been aligned under emf field

[Dave45]

When I first started looking at free energy I read an article that spoke of an invention this young kid came up with, it was a parallel plate capacitor in a doughnut shape that reportedly had thrust.
That was my first build I took the platters out of hard drives and sandwiched them between cd's, then I took a high voltage power supply from a air purifier and fired it up.
Something strange happened or maybe not, you see I was chicken I ran long leads to the unit because I was scared of the high voltage, as I plugged the power supply in, Im not sure if I pulled the capacitor off the table or if it jumped off, I thought at the time it jumped off but it fried the cap, shorted it out so I couldn't try it again, I never attempted to redo the experiment.

We have been looking at crystal's and have ran across claims of negative weight or loss of weight an today I ran across this pdf http://integrityresearchinstitute.or...Valone2008.pdf that has got me intrigued it is a very good read, I dont buy many books but I will be ordering this one.

Keep up the good work I read all your stuff thanks for the idea's I will post when relevant. I have to build and fry, I say that because all my stuff goes up in smoke eventually
If we are going to set the bar set it high
Dave

[IndianaBoys]

first of WOW , is it possible to reproduce it....

MonsieurM,

Here is a reproduction.

The colloidal gold was a couple years old.

Could not locate the same glass container.

This has more of the radiating spikes from the center than is shown in the picture.



This is a 1 ounce shot glass.

Pure water - 0 TDS (total dissolved water) did not produce the radiating spikes

IndianaBoys

[shawnnweed]

I was reviewing videos on Lenz's law and how dropping a magnet into a copper pipe induces a current in the copper by the movement of the magnet. The electrons move in 'eddy currents' or small circular patterns. The magnetic field is repulsed by these currents which slows down the fall. So instead of taking one second the magnets take about an average of four to fall through the pipe. This will not happen in a pvc pipe because it is an insulator and can not induce a current. Of course it is a bad idea to mix HV with magnetics due to cancellation of the mag field. Of course this is not news to any of you but I was wondering what would happen if you placed a longer pvc pipe inside a shorter copper pipe. Hook a power source to the bottom of the copper pipe and another separate wire to the top leading to a light(just to keep the current flowing). Then drop the magnet down the PVC pipe. I have an idea that if eddy currents slow down a falling magnet then a direct current running in the opposite direction of gravity should catch the magnetic field also and see if it slows down even more, stops or even shoots the magnet back out. hmmm

[MonsieurM]

Shawn, guys, now that you know about the solid egg on top of the emf egg ( http://www.energeticforum.com/renewa...tml#post154046 )and all the information i provided, i think you should watch Dr Boyd's video

http://www.energeticforum.com/148789-post127.html

hint: the celt Dr Boyd is showing is an indication of anisotropy , now you can decode what he is saying

[MonsieurM]

MonsieurM,

Here is a reproduction.

The colloidal gold was a couple years old.

Could not locate the same glass container.

This has more of the radiating spikes from the center than is shown in the picture.



This is a 1 ounce shot glass.

Pure water - 0 TDS (total dissolved water) did not produce the radiating spikes

IndianaBoys

there is a big amount of energy stocked in the frozen water , Indianaboys, have you read the glue battery link i posted, me think that frozen water (or not ) + colloidal gold + superglue ( Theo Gray's Mad Science ) + one Copper wire and one aluminum/ or iron wire

could make some super battery...the beauty of it, it can be made very small, but the ratios maybe important

ps: do you see the funnel shapes (ie vortex/egg shape ) and you get the same bump as the one i got using a Smith coil on an air core that was hooked to a battery

i found this here: Adept Alchemy (Robert A. Nelson): Transmutations of Carbon

Inspired by the pioneering work of Dr. Kervran, Dr. George Ohsawa sought to transmute sodium into potassium in vitro. The method revealed itself to him in a symbolic dream. Thus inspired, Dr. Ohsawa and Michio Kushi, et al., constructed an experimental electric discharge tube with copper (Yin) and iron (Yang) electrodes

[shawnnweed]

Shawn, guys, now that you know about the solid egg on top of the emf egg ( http://www.energeticforum.com/renewa...tml#post154046 )and all the information i provided, i think you should watch Dr Boyd's video

http://www.energeticforum.com/148789-post127.html

hint: the celt Dr Boyd is showing is an indication of anisotropy , now you can decode what he is saying

I am not sure what he is trying to say with the celt or how it might apply to antigravity other than to say that maybe the earthsmagnetic field is stopping the rotation of the celt much the same way that a magnet falling through a copper pipe is slowed down only with a different set of principles attached. Such as the Coriolis Effect which is caused by the rotation of the Earth. Others seem to imply that it is anisotrphic sure, but due to what? And what is it that you believe he is implying?
With the stack of balls it is simply a tranfer of energy. All of the interial energy from the total mass was transferred to the smallest ball. If the smallest ball was glued to the others then the total stack would bounce no higher than the distance from which it was dropped. It's a clever trick but a trick nonetheless.

[MonsieurM]

Anisotropy (/ˌænaɪˈsɒtrəpi/) is the property of being directionally dependent, as opposed to isotropy, which implies identical properties in all directions. It can be defined as a difference, when measured along different axes, in a material's physical or mechanical properties (absorbance, refractive index, conductivity, tensile strength, etc.) An example of anisotropy is the light coming through a polarizer. An example of an anisotropic material is wood, which is easier to split along its grain than against it.

quartz and neodymium are anisotropic

------

Steganography is the art and science of writing hidden messages in such a way that no one, apart from the sender and intended recipient, suspects the existence of the message, a form of security through obscurity.

you are still seeing the material world, now what if the universe is all wave , then the 2 balls are both waves...(principle of mentalism )

skunk works....

[Dave45]

Here's a pic if the toroid with ice in the core

Iv been thinking of how to magnify the magnetic field and I think this is what a Tesla coil does if you look at the primary the way that its made like the pancake coil, even without the high voltage pulse the coil is concentrating a field to its core a big field because of the way the coil is laid out.

So the broader the coil the smaller the core the more concentrated the field and if hit with a high voltage pulse bam
I'll have to think this over for awhile

I have the toroid in ice now it has one wind left and one right around the toroid
I made two electrodes out of sheets of aluminum with acrylic as the dielectric between the aluminum posts and inserted them into the core, Im going to hook this up to the function generator in a couple of days if I get anything I'll let it freeze for two or three days and take another reading I have a hunch that if left to form the field will channel through the ice more and more I will keep you posted.
Dave

[Dave45]

Water structure and science

good reading