The Golden Tractate of Hermes Trismegistus applied to electromagnetism

[MonsieurM]

I don't know if i posted this version of the 3 6 9

SVPwiki : 15.18 - Keelys Process for Liberating Ether from Water

SVPwiki : Mass Chord

"The mass chord of any mass is that lowest or fundamental vibration to which that mass is resonant.

"As every mass consists of vibrations in thirds, balanced in harmonic? equilibrium, it stands in harmonic relation to every other mass. All forms of matter and motion are thus interrelated and mutually convertible, one into the other, and through resonance, increasing or diminishing this sympathy, we can control the states of matter." (Keely)

"In his researches Keely discovered a system of obtaining the "chord of mass" or keynote of all substances, whether mineral, vegetable or animal. He does not give or even hint at the method by which this was obtained, and it is supposed this is the "one detail" which he kept secret until his one patentable invention was to have been completed.

but what you have to realize is that he left us a clue....Exploding water with 42712.2Hz...and Harmonic Math will definitely allow you to find the frequency to boil water


from the link on water

Water is a ready and fit subject for vibratory research on account of its "differential volume" and gravity of its gases. Even on simple thirds the differential action between hydrogen and oxygen causes antagonism and dissociation. The differential of mass is such that the hydrogen and oxygen become thoroughly repellant and thereby exhibit thousands of times more force than could be induced by heat on the same amount of water. Vibration of antagonistic thirds, sixths and ninths on the mass chord will compel progressive subdivisions and to get the best effect on water, the instrument is set on all of these. First, the focalizing chord of sixths induces perfect harmony to the mass chord.

[MonsieurM]

and those familiar with Rodin Math:

Exploding water with 42712.2Hz

4 + 2 + 7 + 1 + 2 + 2 = 18 = 1 + 8 = 9

[MonsieurM]

this comes from an interesting article , applicable to Peter Davey's Sonic Boiler

KeelyNet: Joel McClain: Measurement of Resonant frequencies and Harmonics | MERLib.org

April 25, 1994

Thanks to information supplied by Gerald O'Doucharty, as compared with waveform analyses as determined by the late Mr. Les Brown, we can begin to make some progress in the understanding of resonance. I believe that these conclusions are in accordance with the discoveries of both Walter Russell, in his resonance based chart of the elements, as well as those of John Keely.

Les Brown dropped a pebble in a bowl of water, and measured the rings which resulted. From this, he was able to determine the mathematical relationships, which he found to be factors of PI. There is no random pattern to the rings.

The first ring is equal to the diameter of the pebble. The second ring is equal to the diameter of the first ring, times the cube root of PI, or 1.3313. The third ring is equal to the second ring, also times 1.3313. Each ring is a NATURAL HARMONIC of the previous ring. Comparing this with the information supplied by Gerald, we can see that in the diatonic scale, the following relationships exist:

Whole
Note Frequency (Hz) 1st Harmonic (UPPER ORDER)

C 262 F 349.33 Hz
D 294.75 G 393.00
F 349.33 A' 465.06
G 393.80 C 524 (262 X 2)
A 436.66 D 581.33 (294.75 X 2)
C' 524 F 698.66 (349.33 X 2)

Semi- Notes
E 327.50 A 436.66
B 491.25 E 654.00 (327.50 X 2)

Energies, including radio waves, propagate according to the same ratios, based upon the cube root of PI. To an energy researcher, this means:

1. Energies are based upon the atomic model. Therefore, the rings which surround each atom are based upon the size of the nucleus (pebble), and this is the base frequency of the atom. Each ring diameter will be determined by the cube root of PI, times the nucleus, and then times each ring in succession.

2. Once you find the resonant frequency of the nucleus, to resonate the atom, you will need to determine the number of rings, and apply the correct number of harmonics at the correct frequency. This is true for an element, whereas compounds will require each of the fundamental frequencies, plus the harmonics.

Let's say, for example, that a hydrogen nucleus resonates at G, or 393 Hz.

To resonate the aggregate hydrogen atom, you must apply G as well as C, the first harmonic, or 524 Hz. If oxygen has a fundamental frequency of A, or 436 Hz, then you must also apply D, or 589.5 Hz.

To resonate water, you would apply 393, 436, 524, and 589.5. However, this may not be a "hard and fast" rule, because we know that the highest frequency will contain all of the lower frequencies at harmonic intervals, but at lower amplitude.

Therefore, if a single resonating frequency is used, it will have to be of high enough amplitude so that the harmonics are "felt" by the element or compound.

The frequencies in the above example are based upon the arbitrary values assigned in 1939, because they "sound" the best. However, the multiplier of the cube root of PI is a constant. So, when you find the fundamental frequency of an atom, you can apply this constant to resonate the aggregate mass, including the rings.

Just multiply the constant times the fundamental freq for the first ring, and multiply the constant times the first ring for the second ring, etc. As Gerald pointed out, there are inconsistencies in the man-made chart, so experimentation is required. However, Les Brown's constant will apply regardless, ONCE THE FUNDAMENTAL FREQUENCY has been determined.

Referring to Russell's chart of the elements, we find that the number of elements per octave corresponds to the number of whole notes per octave on the diatonic scale. Isotopes consist of semi-notes and harmonics. As such, once we begin to analyze elements, we can quantify Russell's chart, and determine the exact combination of frequencies for each element, isotope and inert gas.

Russell obviously knew these correlations, or he would not have been able to create the chart in the first place. We have to "reverse engineer" the chart to determine the frequencies. Using the cube root of PI, combined with experimentation, I believe that that is possible to do.

[MonsieurM]

[B]

------------------here is a vid for you:

Lakhovsky Multiple Wave Oscillator 1/4 - YouTube


Lakhovsky Multi Wave Oscillator - YouTube

[IMG][/IMG]



and Lakhovsky held the same belief as Tesla On the matter of Cosmic rays

[MonsieurM]

and this one looks a bit...



this one:



and the angle maybe taken from one end of the sphere to the end of the second sphere ....you can trace two lines with both sphere of each ring within those two lines



the last set up reminds you of anyone

[StweenyA]

Would that work kind of how a microwave works?

[MonsieurM]

Would that work kind of how a microwave works?

what do you mean

[MonsieurM]

found the original...did not know it was his design:

[StweenyA]

what do you mean

Sorry, I meant about the water boiling or exploding.

[MonsieurM]

I love it when patterns appear to connect like minded Discoverers



Meet the Tube for producing multiple Wavelength ....Or the Caduceus Tube

[MonsieurM]

Sorry, I meant about the water boiling or exploding.

in a way since all is vibration...but less efficient...think of it as one being a brute force and the other more like a swing using small push to increase vibration of water

[StweenyA]

in a way since all is vibration...but less efficient...think of it as one being a brute force and the other more like a swing using small push to increase vibration of water

Where the microwave is the brute force?

[MonsieurM]

link to the patent:

Patent US2351055 - TUBE FOR PRODUCING MULTIPLE WAVE - Google Patents

[MonsieurM]

Where the microwave is the brute force?

[MonsieurM]

you get to see on of my favorite coils being used as an antenna...SBB Mobius Coil look alike