If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
A variant of the ZVS should improve efficiency, may just need single cap between the coils and no pos lead at all.
Adjusting the 470 ohm resister may be needed.
If it doesnt burn the core up, it could get explosive
Using heavy wire with just a few turns means less resistance, allows the coils to run at a higher frequency, allows the magnetic field to build a collapse quickly.
About the shorted secondary winding should it be of a higher impedance, is there a harmonic relationship here.
Should the shorted secondary be wound cw and ccw as well.
Can this be made into a dual rail use one rail to loop and draw from the other rail.
We are not going to understand or achieve overunity until we start to understand and use both polarity's.
Ole Ben Franklyn was half right, we have two polarity's running in a circuit, and we have to collect both.
. . .
Regular service Signature:
Follow along on my Algae growing adventure, where I'm currently growing Spirulina and two mystery strains (one of which can also produce Biofuel). All is revealed in the Growing Algae thread...
Yes and the Hendershot device, the magnet is also backed with mumetal this could be having an effect as well.
I may play with this a bit, I wonder does he mention the diameter of the core anywhere.
Hmm seems he took the backing off in some of his vids
Comment