If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes but having the supply wires in series as you have shown will cause the circuits to interfere with each other to some extent, it would be better to have each circuit have its own wires to the supply or trigger both coils from one trigger coil. Also on the charging side it would be batter to have the batteries in parallel using separate diodes going to each, this will keep the voltage lower on the charging side.
I need the Parts list for Alexkor circuit which is the same as the one you mentioned in the thread. Please send me one copy to irdex@hotmail.com
Note:
Alexkor circuit only mentioned that a 2700 pf capacitor is needed but it doesn't specify what types of capacitor to be needed. I'm quite confused. When I search for the text "2700 pf capacitor", eBay return the following 9 results:
1. Philips Metallized Film Capacitor 2700pF 250V
2. 2700pf/500V Silver Mica Capacitor
3. 2700pF 15KV DC High Voltage Ceramic Disc Capacitor
4. CAPACITOR 2700PF 2000V
5. Panasonic Polyester Film Capacitor
2700pF 50V 5% ECQ-B
which one should I choose? (is sealed lead acid battery the best?)
----------------------------------------------------
Four 12V 12AHr battery are needed for the Alexkor circuit, I found the batteries needed on ebay. Is the following item the one for being the 12V 12AHr battery (total 4 battery is needed) for the Alexkor Circuit?
What types of diode I should buy on ebay for the Alexkor circuit (the first one not the advanced Alexkor circuit), can you do me a favor by searching on ebay and give the result for the diode? Also, how about the neon and 2000ohm resistor? Search for me on ebay and sent me the result. Thanks
----------------------------------------------------------
Lastly, I want to asked how about earthing on Alexkor circuit? Does Alexkor circuit need earthing for electrical safety to protect me from electric shock from electric leakage of Alexkor circuit? Or the Alexkor circuit is safe enough that no earthing is needed for Alexkor circuit?
Please REPLY to answer my questions via email(irdex@hotmail.com) or in this thread.
Comment