My first successful Bedini (Simplified SGC with extra coil))

[d0m1n0o]

So, thanks to Bediniīs coil winding video I made a beautiful coil with 0,3mm and 0,45mm wire.
Approx 28 and 25 AWG
No idea about how many turns it has, maybe too many?
With that coil alone the motor wouldnīt start, so I connected another coil in parallel to the driving coil.

The strange thing is that now itīs working even when the trigger coil isnīt placed by the rotor ANY explanation for this?

The circuit is this one:
http://rpmgt.org/Schematic2.jpg

Here it is, charging a 8.4V block, quite full in 1/2 Hr



I used Self-vulcanizing tape and it turned out to finish in Spiderman style


My pots seem to die FAST, any suggestion?

Thanks

[ajidabomb]

23 and 26 #awg

is that ok if i use power coil with diameter 1mm and trigger coil 0.5 mm.... your motor and your air gap seem large.... i think if u get closer with coil, u would get higher rpm i think

[aguy]

a good start

TexlagenX - Prewound coils
1x20AWG+1x23AWG 130' for you is 20-run 23 trigger

rotor to small no flywheel effect [mass tn motion]


Bedini SSG Monopole Energizer Motor Kit