Bill William’s 5X5 CDGSC Gas splitter dry cell

[ashtweth]

Hi Bill /ALL

yes Reg, Bill W and myself left him a message he claims he had no knowledge of the design being open source, this i am yet to believe and are still investigating it

Ash

[swompwalker]

A pump may well have a noticeable influence on hydrogen production. Such a pump:

DC 12V Electric Water Pump 103 GPH (P-38I) UK | eBay

Also shippable to OZ and the USA in local currencies

[n84dafun]

Comparison of H2, O2, and HHO Ignition

Here's a side by side comparison of the different ignition results of the three gases. You can see my video here: GSC Hydrogen vs Oxygen vs HHO Ignition - YouTube

It has 2 sets of 5 neutral plates and three active plates. I guess that would be a 2N5, or is it 5N2? I forgot how to designate it.

[n84dafun]

Breakdown of GSC

Here's a video of me taking apart the GSC cell after a few hours of running. Ignore the little hand that pops out near the beginning.

Breakdown of GSC Electrolyzer - YouTube

[n84dafun]

Rebuild of GSC

Here's my rebuild. Works great so far. No leaks noted. Running at 15 to 16 Amps and around 13 to 14Volts. Set up is +NNNN-NNNN+ Plates are 4.5 by 5.8 inch, thin gauge 316L SS. Gasket thickness is about 1/8 inch (1/16 EPDM + ripstop_nylon + 1/16 EPDM)

GSC Rebuild - YouTube

[ashtweth]

Well done man thank you so much for posting

[n84dafun]

GSC Hydrogen Separator Cell Installed in Honda Odyssey

I finally got a chance to install the GSC in my vehicle. Here's the video:

Gas Separator Cell (GSC) installed on Honda Odyssey - YouTube

I'll post the MPG in a few weeks!

-brian

[ashtweth]

Hi Brian/All.

Brian really nice work, thank you so much for the detailed description, 15amps is a good start, i would also try and experiment with lower amps, i have seen that work a few times, is there a sweet spot with hydrogen? i know i have seen it with Ti, Bill's cell looks wonderful man. Really nice looking work, i dont know how you filmed all that with one hand man.

Ash

[n84dafun]

Hi Brian/All.

Brian really nice work, thank you so much for the detailed description, 15amps is a good start, i would also try and experiment with lower amps, i have seen that work a few times, is there a sweet spot with hydrogen? i know i have seen it with Ti, Bill's cell looks wonderful man. Really nice looking work, i dont know how you filmed all that with one hand man.

Ash

Thanks Ash. One handed filming is a challenge...I tried taping the phone/camera on a face shield on one of my videos, but it was awkward.

I'll try the lower amps like you said. Probably better for the engine/alternator. I'd like to try the Titanium negative active plate as well. I wonder how hard it is to drill/cut that metal.

-brian