Fuel cell and atomic hydrogen

[tachyon]

final version to test cartridges with various catalysts

what is the filter after the laser beams? nvm its heating cartridge I'm not good with Italian :P

why do you put aluminum inside water with salt? you need vacuum for the container like this..

why not recycle back the hydrogen if this is a closed system?

[Franco malgarini]

each time produce hydrogen with the reaction aluminum-caustic soda but then recycle the hydrogen produced in the reactor





________________________________
http://autocostruire.forumcommunity.net/

[tachyon]

ok.. good luck with it.. what laser beam do you use for electron excitation ?

[Franco malgarini]

The literature says to use UV lamps.
I used the laser should do with a laser pointer

[tachyon]

The literature says to use UV lamps.
I used the laser should do with a laser pointer

what wavelength and energy is used ?

[Franco malgarini]

naturally UV...

[tachyon]

read pm .....

[Franco malgarini]

I put a mirror at the end of the reactor to trap the laser beam:

[Franco malgarini]

practically with a laser pen and a bit of hydrogen can heat home

[tachyon]

Which electron bands of hydrogen ( WAVELENGTH ) must be excited for dissociation? I'm guessing you're mixing two SPECIFIC frequencies together not just a laser pen from chinamart...be more specific please!

grazie signore franco malgarini rispondere ai miei messaggi per favore

[Franco malgarini]

Do not know the optimum wavelength but ri can be derived by calculation or by experiment. But we must absolutely use a UV laser pointer because the equipment must be cheap.
Sure, Tachion, you can also use oxygen, nitrogen, deuterium depending on the result you want to achieve ...




_______________________________
Autocostruzione

[Franco malgarini]

As you can see the generator has zero emissions.
Laser pointer on the market are just a few euro
the following wavelengths:

405 nm
445 nm
532 nm
650 nm

[Franco malgarini]

One molecule of diatomic hydrogen H2, passing through an electric arc between tungsten electrodes, splits into hydrogen atoms by absorbing a considerable amount of heat:
H2 + 103Kcal = H + H = H2 + 103Kcal
Atomic hydrogen, recombining into molecules, being unstable, after 0.5 seconds, gives a temperature of 4000 ° C.
In the literature, however, also speaks of UV lamp to operate this division and is considered a laserUV that sends its beam of light into the reactor, where it circulates hydrogen, the leaders of which there are two mirrors, one normal and one semireflecting. In this way the laser beam remains trapped inside the reactor, providing, from a certain point onwards, the energy required to trigger the cleavage of the hydrogen molecule. The right end of the reactor and then escapes atomic hydrogen H1 that, inside the heat exchanger, it recombines immediately into hydrogen H2 and providing the 4,000 ° C useful to heat the water in the circulation.
The molecular hydrogen H2 riformatosi, is then returned to the entrance of the reactor, which is thus self-sustaining.
And 'only need a bit of hydrogen H2 outside every time you turn the device.

[tachyon]

No you need a quartz tube aluminated on the outside and plainted black and only on the sides make one way mirror with aluminum paste and then put a 405nm laser on one side and 650nm laser on the other side.. I guess 200mW will be sufficient have to calculate later.. we also need a circulator and other stuff..

giorgio

[Franco malgarini]

Tachyon, you can draw a picture?