Tweet
Hey. I am new to this thread. I have had an interest in electronics and magnetism for a while know. I had been looking into the Bedini SSG motor and finally finished my first one yesterday (4/13/2013). I used the Daftman layout. It made it simple to wire it up. I used 750 winds on my coil of #26 and #23 AWG magnet wire. My power source is a Craftsman 19.2 NiCad and my charging battery was a dead 9V alkaline. I replaced the 9V battery with a disposable camera circuit that included a 80UF 330V cap. It has been about an hour and my Craftsman battery is holding steady over 19V and the voltage at the camera circuit holds steady at 198V. I don't have an Oscope so it makes it hard to see what is going on with the frequency. I have not taken any "I" readings yet. Here are some pictures. Feel free to comment.
DMann
DMann
Comment