Tweet
If anymembers are working on LENR or CF reactors I have Questions about My results and Power extraction method. Surely I'm measuring something wrong 120 V a/c diod plug to 120 dc in. After heating up cell near boiling.I use 230 v too warm up then switch to 120.At this point it runs on .5 too .8 amp. Once I start extracting the energy the input drops apx. .15 va to 20 watts and I'm extracting 150 dc 8 amps + . pink glow goes to whitesh sparkler look. Red glow dissapates from rod. The more you try to extract. the lower the input drops. Also the plasma will not appear unless I have a load on it. Once it reaches this level it seems to restart on lower voltages too. It also has one other Odd effect. The way to extract!!! I'm Using a 128 v 9.5 amp 1.41 hp servodisc. I can load the servodisc to practly a stall and the input on the cell actually drops to 5 watts. Yea I know dosn't sound right. I will rerun test again tomorrow. I don't have the best measuring equipment just a dig volt meters and a P3 killowatt meter on the A/C outlet. dig meter on the extraction point. more to follow might just be a fluke on my part. Randy