Self-induction

[erfinder]

Hi Steve,

It is strange that for the last 2 months I have been messing with my pulse
motor using the diodes as you depict in your last post.

My findings to this point are -

* the voltage average (+ rail) seems to pulse and read higher
* my scope shows 2x to 3x higher voltages
* power consumption increases and rpms rise dramatically
* my mechanical switching goes into overdrive

I've even tried to pull output from this increased + rail.

Still, what comes out (bemf) seems to go inline with that which is input.

I took the idea for the diodes coming from the supply from the magnacoaster patents.

Think I'll pop up a small video.

Cheers, Garry

Hello Garry,

I'd really enjoy seeing what you've been up to.

Regards

[Cornboy 555]

Energy cannot be created or destroyed, it can only be changed from one form to another

HyperPhysics

@ Duncan, there's no dought we have all been subject to an enormous scam, involving paying for Energy etc, since time began, as we know it in our short lifetime.

Your theories on SERIES resonance, really ring a bell to me, and i will test that as soon as i can.

Thanks Erfinder, for having the courage, to start this thread, you have my respect, and i look forward to your'e disclosures, of your Practical Experiments.

Regards Cornboy.

[Duncan]

Part 3 of 6: Eric Dollard Tesla Longitudinal Wave Energy SBARC Ham Radio with Chris Carson - YouTube

The result of this is you end up seeking an answer with the only language you have available but you can see there is a whole dimension with its maths and science missing.
Its not that I can put all the theory back in place , I can't, but I do know where something is supposed to be because of the radio system , and some slight knowledge of the grid system. I can just about engineer on what isn't there .. if you see what I mean . I can extrapolate backwards. (practically at least)
So in the case of self induction .. having separated the two with resonance why not wind identical coils and reverse one of them ? What was a foe in opposition is now a friend in assistance. So you see erfinder I crossed Mordor but perhaps its not the answer you are seeking because I have used 'low cunning' rather than tackle the puzzle that has been intentionally put in place by the best that the era could muster a hundred years or so ago. And you have to confess they did a pretty good job.

[Cornboy 555]

Hey Duncan, you're a dude, sorry for being OFF topic, but just wanted to say thanks for all your input on this forum, you have obviously come from a hard place, and i feel everyone respects your nevergiveup, input.

Thanks and regards Cornboy.


PS. This is not Tounge in cheek, i really respect You.

[erfinder]

@ Duncan, there's no dought we have all been subject to an enormous scam, involving paying for Energy etc, since time began, as we know it in our short lifetime.

Your theories on SERIES resonance, really ring a bell to me, and i will test that as soon as i can.

Thanks Erfinder, for having the courage, to start this thread, you have my respect, and i look forward to your'e disclosures, of your Practical Experiments.

Regards Cornboy.

Hello Cornboy,

Its all practical, its just a matter of interpreting it as such. As far as the experiments go. They aren't going to excite anyone who isn't making connections already between whats being suggested and what they are working on. If any part of this "disclosure" (uh...one must have something before it can be considered as a disclosure....I haven't made any claims that I'm aware of...) aids anyone I am happy. All I'm interested in is an exchange of ideas, right or wrong is immaterial.

I really appreciate you being here.


Regards

[Mario]

Hi Steve,

since you haven't added anything regarding my last post I take it that we agree.
There is one thing I'm not sure we're on the same page though, regarding what you said earlier:

The idea is to connect the coils in such a manner that from the electrical point of view, the coils operating in electrical opposition (bucking), and magnetically in series (not really sure about this, if the coils are electrically bucking

To simplify the terminology, do we agree that when the coils (which are all connected in series) are energized with a short pulse at TDC, they all push the magnets that are in front of them away?

regards,
Mario

[erfinder]

Hi Steve,
since you haven't added anything regarding my last post I take it that we agree.

Not quite on the same page yet, but we will get there in time, I truly appreciate your questions, as they enable me to organize my thoughts about whats going on, inside my motors. The reason I haven't replied yet, is because I'm still preparing the post. It takes me a few minutes to type them up. Since you are not asking for cold hard facts, which I couldn't give even if I wanted to, I must take my time and prepare my response to your question carefully.

There is one thing I'm not sure we're on the same page though, regarding what you said earlier:

To simplify the terminology, do we agree that when the coils (which are all connected in series) are energized with a short pulse at TDC, they all push the magnets that are in front of them away?

regards,
Mario

It's all speculation.


Regards

[Mario]

[erfinder]

Steve, no worries, take all the time you need. At this very moment I couldn't replicate the setup anyway as right now I don't have a N-S-N-S rotor. I have the things I need to do so though, but right now I'm still working on a pure resonant solid-state circuit. Still, the questions I ask are because I intend to investigate this on the bench soon and I want to be sure I have understood the setup correctly and the way things are connected.

Being able to share with a like mind is all I am here for.

Regards

[Mario]

Steve, your SG with the modified wiring in the video, does it also have the mags in NSNS configuration?

regards,
mario

[erfinder]

Steve, your SG with the modified wiring in the video, does it also have the mags in NSNS configuration?

regards,
mario

Yup, the magnets alternate.


Regards
Steve

[erfinder]

https://dl.dropboxusercontent.com/u/...troduction.wmv

[erfinder]

https://dl.dropboxusercontent.com/u/...20Part%202.wmv

[erfinder]

Is this the same effect that is keeping the Ferris Wheel primary battery bank charged? I don't know, I would like to think it is.
My two cents..


Regards

[Mario]

Hi Steve,

thank you for the videos and explanations. Since I have a little and ready SG laying around I couldn't help trying what you show, even if it's all N out. This little model has an adjustable hall trigger, so I could easily switch between O crossing and peak crossing.
I put a 3300 uF buffer cap between supply and SG (with diode before the cap) and when I got to 0 crossing and disconnected the hall I did see the buffer going from about 14.5V to 20V, the supply was at 15V.

I think I know what is happening. When we switch to 0 crossing (max speed) the generated voltage goes above the supply. When we turn off the hall the coils with flywheel effect are still generating and are powering the recovery buffer (your lamp), AND the supply buffer, but this through the FET reverse diode